OEM 2002 Ford Ranger Automatic Transmission Filter

2002 Ford Ranger Automatic Transmission Filter Parts Questions & Experts Answers

• Q: How to Service and Repair the Automatic Transmission Filter on 2002 Ford Ranger?

  A: The repair process begins by unscrewing the transmission servo heat shield when it exists on the fluid pan rail then setting it apart from the work area. A drain pan should be set under the transmission fluid pan prior to draining the transmission fluid. Begin by removing all transmission fluid pan bolts except the two on the front panel and then loosen the front screws before carefully prying down the rear part to drain fluid before removing the front screws. The old gasket and filter must be discarded while you should clean all mating surfaces of the fluid pan and magnet before inspection. A thorough flushing process needs to be applied to transmission fluid cooler and lines. The first installation step requires applying automatic transmission fluid to new fluid filter O-rings to prevent damage followed by installation of the new filter to the main control valve body without wire harnesses pinched. Attach the oil pan magnet into the fluid pan before you install the new gasket and align the pan and loosely position screws which will later be tightened in intersecting patterns. When servicing is necessary for this system you should reposition the servo heat shield and clamp it onto the pan rail. The supplied instructions should be followed to install a fluid filter kit when the vehicle previously lacked one. Begin by lowering the vehicle while even pressing the parking brake before starting the engine. The first step when replacing transmission fluid in a dry system includes pouring 3.7 liters (4 quarts) of clean fluid. Afterward, perform a check for normal operation by moving the range lever through all positions. Finally, verify the fluid level.