FordParts
My Garage
My Account
Cart
OEM 2002 Ford Windstar Automatic Transmission Shift Levers
Automatic Transmission Shifter- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Automatic Transmission Shift Levers found
2002 Ford Windstar Shift Lever Part Number: XF2Z-7210-AA
Product Specifications- Other Name: Shaft - Gear Change; Automatic Transmission Selector Handle; Gear Shift Assembly
- Manufacturer Note: Incl. knob and wire assy
- Base No.: 7210
- Item Weight: 0.80 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: XF2Z-7210-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2002 Ford Windstar Automatic Transmission Shift Levers
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2002 Ford Windstar Automatic Transmission Shift Levers available at FordPartsDeal.com. You can confidently purchase our OEM 2002 Ford Windstar Automatic Transmission Shift Levers as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2002 Ford Windstar Automatic Transmission Shift Levers Parts Q&A
- Q: How to Service and Repair Automatic Transmission Shift Levers and Cables on 2002 Ford Windstar?A: The procedure for servicing the shift cable and automatic transmission shift levers begins with air bag safety precautions through power supply reduction and a one-minute waiting period for both ground cables and any auxiliary batteries and power supplies. The service starts with unscrewing the two components holding the instrument panel lower steering column opening cover before removing the left-hand instrument panel finish panel from the instrument panel followed by removing the right-hand finish panel. Take out the screws that mount the instrument panel opening cover reinforcement as well as the steering column opening brace. The automatic transmission shift lever indicator cable must be positioned to the side so its screw can be loosened while disconnecting the cable. To remove the ignition switch lock cylinder first set the key to RUN position while pressing the lock release pin and pulling it out. Begin by taking off the lower steering column shroud through a process that potentially involves removing tilt wheel handle and shank components and requires three screws to be unfastened. Screw remover in four nuts from the bracket and steering column lowering process followed by upper steering column shroud detachment. The installer must disconnect the Transmission Control Switch (TCS) harness connector and separate the TCS harness from both the locators along with the gearshift lever cover from the steering column. As a vital step you should replace the old gearshift lever pin then remove the gearshift lever. The reverse process of installation should follow removal procedures.