FordParts
My Garage
My Account
Cart
OEM 2002 Lincoln LS Steering Angle Sensor
Steering Column Angle Position Sensor- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Steering Angle Sensor found
2002 Lincoln LS Steering Sensor Assembly Part Number: YW4Z-3F818-AA
Product Specifications- Other Name: Sensor - Steering Rod; Steering Wheel Speed Sensor; Steering Angle Sensor; Sensor; Sensor - Steering Rotation
- Replaces: XW4Z-3F818-AA
- Base No.: 3F818
- Item Weight: 0.30 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: YW4Z-3F818-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2002 Lincoln LS Steering Angle Sensor
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2002 Lincoln LS Steering Angle Sensor available at FordPartsDeal.com. You can confidently purchase our OEM 2002 Lincoln LS Steering Angle Sensor as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2002 Lincoln LS Steering Angle Sensor Parts Q&A
- Q: How to service the Steering Angle Sensor on 2002 Lincoln LS?A: Service procedures for the Steering Angle Sensor must start with disconnecting the battery ground cable. First pull the lower steering column opening finish panel by removing the screws until it extends enough to reach the electrical connectors. After disconnecting these connectors remove the finish panel. After disconnecting the hood release assembly with its screws you need to detach the heater duct and screw from the system. Unfasten the bolts holding the carpet from the console tunnel and unscrew four screws which separate the steering column opening reinforcement. Disconnect the steering wheel rotation sensor while detaching the electric tilt/telescoping motor electrical connectors before proceeding to disconnect the other electrical connectors. Support the steering column first and then remove both lock nuts and the steering column discarding the nuts. Remove screws before you separate the electrical connector from the steering column as well as removing the sensor. The reverse order of uninstalling procedures will finish the installation.