OEM 2002 Lincoln Navigator Cruise Control Servo

2002 Lincoln Navigator Cruise Control Servo Parts Questions & Experts Answers

• Q: How to service and repair the cruise control servo on 2002 Lincoln Navigator?

  A: The first step for servicing and repair of the cruise control servo requires the cable cap of the speed control actuator to be removed from the speed control servo through a combination of pushing in the locking arm and turning the cap counter-clockwise. The procedure starts by removing the speed control actuator cable through its core wire end which must exit the speed control servo pulley after spring retainer depression. The operation to disconnect the speed control servo electrical connector requires depressing its connector tab and extracting it from its position. Lessen the bolts from the speed control servo while keeping the rubber grommets steady inside the speed control servo bracket. Move on to the removal of the speed control servo bracket by untightening its screws. The installation process starts by properly seating the rubber grommets on the speed control servo bracket to achieve noise and vibration reduction performance. To install the speed control servo keep the speed control cable slug inside the speed control servo pulley slot before releasing the spring tension while retaining spring compression. After placing the speed control actuator cable cap tabs inside the speed control servo housing slots let go of the compressed spring to confirm complete rubber seal position on the speed control actuator cable cap for preventing high idle conditions. The last step involves rotating the speed control actuator cable cap until the locking arm sets into place.