OEM Lincoln Navigator Cruise Control Servo

Lincoln Navigator Cruise Control Servo Parts and Q&A

• Servo Assembly
  XL3Z-9C735-BA
  Q: How to service and repair the cruise control servo on Lincoln Navigator?

  A:

  Serviceable steps for the cruise control servo start with removing the speed control actuator cable cap from the speed control servo through the process of pushing in its locking arm followed by counter-clockwise rotation of the cap. The speed control actuator cable must be disconnected at the speed control servo pulley through the process of depressing the spring retainer while sliding the core wire end free of the pulley. You should detach the speed control servo electrical connector after depressing its connector tab. Unscrew the bolts from the speed control servo yet keep rubber grommets from separating from the speed control servo bracket. To proceed with the removal you must disconnect the speed control servo bracket through its screw mount. Install the speed control servo bracket by first positioning the rubber grommets properly because this step ensures appropriate noise and vibration isolation. The speed control cable slug should be placed in the speed control servo pulley slot while a conscious effort is made to compress the speed control servo spring. Shift the speed control actuator cable cap tabs into the speed control servo housing slots then free the compressed spring while making sure the rubber seal fully reaches the speed control actuator cable cap to stop high idle conditions. Embed the locking arm of the speed control actuator cable cap by continuing to rotate the cap until it locks in position.