My Garage
Cart

OEM 2003 Ford Escape Antenna Cable

Radio Antenna Cable
  • Select Vehicle by Model
  • Select Vehicle by VIN
Select Vehicle by Model
Make
Model
Year
or
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Antenna Cable found

  • 2003 Ford Escape Antenna Cable - YL8Z-18812-AA
    2003 Ford Escape Antenna Cable Diagram - YL8Z-18812-AA
    View related parts

    2003 Ford Escape Antenna Cable Part Number: YL8Z-18812-AA

    $15.57 MSRP: $21.19
    You Save: $5.62 (27%)
    ADD TO CART
    Product Specifications
    • Other Name: Cable Assembly - Extension; Cable
    • Base No.: 18812
    • Item Weight: 0.70 Pounds
    • Item Dimensions: 9.2 x 3.0 x 10.4 inches
    • Condition: New
    • Fitment Type: Direct Replacement
    • SKU: YL8Z-18812-AA
    • Warranty: This genuine part is guaranteed by Ford's factory warranty.
    More Info
    Fits the following 2003 Ford Escape Submodels:
    • Hybrid, Limited, XLS, XLT, XLT No Boundaries, XLT Sport | 4 Cyl 2.0 L GAS, 4 Cyl 2.3 L FULL HYBRID EV-GAS (FHEV), 4 Cyl 2.3 L GAS, 6 Cyl 3.0 L GAS

2003 Ford Escape Antenna Cable

If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2003 Ford Escape Antenna Cable available at FordPartsDeal.com. You can confidently purchase our OEM 2003 Ford Escape Antenna Cable as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.

2003 Ford Escape Antenna Cable Parts Q&A

  • Q: How to service and repair the upper antenna cable on 2003 Ford Escape?
    A: Service and repair of the antenna upper cable can start with removing both the audio unit and right lower A-pillar trim. You should first disconnect the antenna cable connector then bring down the glove box door. Three pin-type retainers securing the lead-in cable need removal before the antenna cable clip fastened to the center instrument panel support can be removed. The cable removal process ends by removing it from the glove box opening. Uninstall the system by performing a backward process during assembly procedures.