OEM 2003 Ford Thunderbird Window Regulator

2003 Ford Thunderbird Window Regulator Parts Q&A

• Q: How to service and repair the front door window regulator on 2003 Ford Thunderbird?

  A: The procedure to repair or service the front door window regulator starts with removing any removable top components then detaching the front door trim panel and setting the front door watershield to the side. Join the window switch with the battery ground cable after which lower the window fully. Service the components in sequence according to their stated removal order. You can reach the door window clamp bolts after the correct positioning of the window glass while you should also disconnect the electrical connector to remove the window regulator nut. After reversing the removal steps you need to verify that the door window glass fits entirely into the window regulator clamps before installing the bolt and sleeve components without applying any torque. Pull out the screw as well as the no. 4 convertible top weather strip while keeping in mind that full closure of the convertible top blocks access to this screw. To insert the 13 mm (0.52 in) wedge between the no. 4 frame and the top of the glass while keeping door window glass at full up position when the convertible top and door are both closed. After clamping down the door window regulator bolts tighten them then eliminate the wedge to let the window reach its lowest position. Secure the pin-type retainer into the weather strip moulding by installing the beltline moulding. The final step involves installing the no. 4 convertible top weather strip along with the screw when the convertible top is in a complete closed position before inspecting correct window glass operation through door window glass movement to make any required adjustments.