FordParts
My Garage
My Account
Cart
OEM 2003 Ford Windstar Mass Air Flow Sensor
MAF Sensor Meter- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Mass Air Flow Sensor found
2003 Ford Windstar Mass Air Flow Sensor Part Number: 3W4Z-12B579-AC
$157.79 MSRP: $259.64You Save: $101.85 (40%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Sensor Assembly; MAF Sensor; Air Mass Sensor
- Replaces: 3W4Z-12B579-AB
- Base No.: 12B579
- Item Weight: 0.30 Pounds
- Item Dimensions: 6.2 x 4.1 x 4.2 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 3W4Z-12B579-AC
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2003 Ford Windstar Mass Air Flow Sensor
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2003 Ford Windstar Mass Air Flow Sensor available at FordPartsDeal.com. You can confidently purchase our OEM 2003 Ford Windstar Mass Air Flow Sensor as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2003 Ford Windstar Mass Air Flow Sensor Parts Q&A
- Q: How to Service the Mass Air Flow Sensor on 2003 Ford Windstar?A: The service procedure for the Air Flow Meter/Sensor begins with disconnecting the battery ground cable as well as opening the air cleaner. Remove the MAF sensor extension harness connector from the wiring harness then release the air cleaner clamp and divide the air cleaner between its inlet and outlet sections while avoiding damages to flow bypass MAF sensing elements to prevent unit failure. A single service operation exists for the MAF sensor module together with its body unit. You should start by cutting the tape around the extension harness wire loom then peeling it back by the air cleaner grommet. Slide the air cleaner grommet down the extension harness after removing it from the outlet side of the cleaner. Disassembly starts with removing the MAF sensor plate alongside the MAF sensor from the outlet side of the air cleaner after which you must disconnect the MAF sensor electrical connector from the extension harness before removing the nuts to separate the MAF sensor plate from the MAF sensor. The reverse order of installation should be followed with special attention paid to fully seating the grommet at the engine air cleaner housing extension to block unmetered air from entering the engine. The alignment notch serves to position the inlet and outlet parts of the air cleaner unit properly.