FordParts
My Garage
My Account
Cart
OEM 2004 Ford E-150 Brake Booster
Brake Power Booster- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Brake Boosters found
2004 Ford E-150 Brake Booster Part Number: 5C2Z-2005-BA
Product Specifications- Other Name: Booster Assembly - Brake; Power Brake Booster
- Base No.: 2005
- Item Weight: 9.50 Pounds
- Item Dimensions: 12.2 x 11.9 x 13.5 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5C2Z-2005-BA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2004 Ford E-150 Brake Booster Part Number: 3C2Z-2005-CA
Product Specifications- Other Name: Booster Assembly - Brake; Power Brake Booster; Booster Assembly
- Base No.: 2005
- Item Weight: 13.00 Pounds
- Item Dimensions: 11.0 x 11.3 x 14.2 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 3C2Z-2005-CA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2004 Ford E-150 Brake Booster
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2004 Ford E-150 Brake Booster available at FordPartsDeal.com. You can confidently purchase our OEM 2004 Ford E-150 Brake Booster as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2004 Ford E-150 Brake Booster Parts Q&A
- Q: How to bleed the Hydro-Boost power brake booster on 2004 Ford E-150?A: A bleeding procedure on the self-bleeding Hydro-Boost power brake booster starts with filling the power steering oil reservoir with clean automatic transmission fluid. After removing the PCM relay you should crank the engine for several seconds to allow bleaching. The power steering oil reservoir fluid requires inspection before the PCM relay reinstallation if the fluid level is low. Begin the engine operation then guide the steering wheel through two complete stops while running before stopping the engine. Rephrase the brake pedal several times to remove residual pressure from the accumulator then repeat the former procedure. Engine operation must be stopped immediately if foam appears before engine users give the foam enough time to disappear. Rephrase the procedure multiple times to eliminate all air from the system until foaming ends.