FordParts
My Garage
My Account
Cart
OEM 2004 Ford Expedition Vapor Canister
Fuel Vapor Canister- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Vapor Canisters found
2004 Ford Expedition Vapor Canister Part Number: F65Z-9D653-AA
$85.64 MSRP: $140.91You Save: $55.27 (40%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Reservoir Assembly; Vapor Canister Purge Solenoid
- Base No.: 9D653
- Item Weight: 2.20 Pounds
- Item Dimensions: 10.1 x 4.5 x 6.1 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: F65Z-9D653-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2004 Ford Expedition Vapor Canister Part Number: 2L1Z-9D653-BA
Product Specifications- Other Name: Cannister - Fuel Vapour Storage; Cannister - Fuel Vapour Store
- Manufacturer Note: Complete Asy - Bracket, Canister And Hoses
- Base No.: 9D653
- Item Weight: 9.30 Pounds
- Item Dimensions: 23.6 x 21.7 x 12.5 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 2L1Z-9D653-BA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2004 Ford Expedition Vapor Canister
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2004 Ford Expedition Vapor Canister available at FordPartsDeal.com. You can confidently purchase our OEM 2004 Ford Expedition Vapor Canister as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2004 Ford Expedition Vapor Canister Parts Q&A
- Q: How to Service the Vapor Canister on 2004 Ford Expedition?A: Start the service of the evaporative emission control canister by disconnecting the battery ground cable to prevent fuel vapor explosions or fires. To begin remove the spare tire and carefully raise and support the motor vehicle. The technician should disconnect the fuel filler pipe remote vapor hose followed by disconnecting the fuel vapor hoses which attach to the Evap canister. Begin by removing the canister assembly mounting bolts then you can separate the Evap canister bracket assembly before disconnecting the vent solenoid electrical connector. The bracket assembly should be placed on a clean work surface after which the vapor connector sleeve needs removal and the vapor hose must separate from the vent solenoid before disconnecting the Evap canisters. The installation requires Merpol(R) lubrication of O-rings before executing the reverse removal steps. A leak test of the system should follow installation with an additional requirement to execute the evaporative emissions repair verification drive cycle to verify proper system functionality.