Other Name: Seat Belt Assembly; Seat Belt Lap and Shoulder Belt, Front Right; Belt
Manufacturer Note: (-P*)
Position: Front Passenger Side
Replaces: 1L2Z-78611B08-AAC
Base No.: <611B08
Item Weight: 3.20 Pounds
Condition: New
Fitment Type: Direct Replacement
SKU: 2L2Z-78611B08-AAA
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
More Info
Fits the following 2004 Ford Explorer Submodels:
Eddie Bauer, Limited, NBX, XLS, XLS Sport, XLT, XLT Sport | 6 Cyl 4.0 L FLEX, 6 Cyl 4.0 L GAS, 8 Cyl 4.6 L GAS
2004 Ford Explorer Seat Belt
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2004 Ford Explorer Seat Belt available at FordPartsDeal.com. You can confidently purchase our OEM 2004 Ford Explorer Seat Belt as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2004 Ford Explorer Seat Belt Parts Q&A
Q: What Safety Measures Should Be Taken When Disposing of an Undeployed Seat Belt Pretensioner from a Scrapped on 2004 Ford Explorer?
A: It is essential to wear safety glasses when disposing of undeployed safety belt pretensioners from scrapped vehicles since remote deployment should happen outdoors while maintaining at least a 6.1 meters (20 feet) distance for all personnel safety. Protective hearing equipment must be worn by everyone during force deployment since this produces loud noises. Safety belt buckle pretensioners and retractor pretensioners should never be placed so their movable components can reach the support surface since this creates potential ricochet hazards. The first step is system depowering followed by extraction of safety belt buckle pretensioner assembly from the vehicle. To wire safety belt buckle pretensioners without electronic connectors, disconnect the main seat wire harness electrical connector and keep four inches of wire extension for attachment. The electrical connector goes back to the safety belt buckle pretensioner and you strip wire sections near the connector. Prepare two wires with at least 20 gauge and a length of 6.1 meters to which you will connect their ends to pretensioner wires of the safety belt buckle. Set the assembly on a level open ground where all moveable elements stay at least 6.1 meters from each other and from contact with the ground. Users can activate the safety belt buckle pretensioner by joining its disconnected wires to a 12-volt battery terminals. The operator should wait for at least ten minutes followed by an approach to the pretensioner after its deployment before conducting disposal actions following regular scrapping guidelines.