How to service the thermostat housing on 2005 Ford Five Hundred?

To maintain the thermostat housing, drain the cooling system, take off the air cleaner assembly and disconnect different hoses. Fit the bolts which hold the housing and discard the O-ring. Install the new housing using lubricated O-ring, screw in bolts to a tightness of 10 Nm, and fill up the cooling system.

OEM 2005 Ford Five Hundred Thermostat Housing

Engine Coolant Thermostat Housing

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Thermostat Housing found

View related parts
2005 Ford Five Hundred Thermostat Housing Part Number: 5F9Z-8592-BA
Product Specifications
- Other Name: Connection Water Outlet; Engine Coolant Thermostat Housing; Thermostat Housing Cover; Thermostat Cover; Water Outlet; Connection - Water Outlet
- Base No.: 8592
- Item Weight: 1.10 Pounds
- Item Dimensions: 6.1 x 6.1 x 7.9 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5F9Z-8592-BA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
More Info
Fits the following 2005 Ford Five Hundred Submodels:
- Limited, SE, SEL | 6 Cyl 3.0 L GAS

2005 Ford Five Hundred Thermostat Housing

If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2005 Ford Five Hundred Thermostat Housing available at FordPartsDeal.com. You can confidently purchase our OEM 2005 Ford Five Hundred Thermostat Housing as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.

2005 Ford Five Hundred Thermostat Housing Parts Q&A

Q: How to service the thermostat housing on 2005 Ford Five Hundred?
A: To maintain the thermostat housing, drain the cooling system, take off the air cleaner assembly and disconnect different hoses. Fit the bolts which hold the housing and discard the O-ring. Install the new housing using lubricated O-ring, screw in bolts to a tightness of 10 Nm, and fill up the cooling system.