FordParts
My Garage
My Account
Cart
OEM 2005 Ford Freestyle A/C Condenser
Air Conditioning Condenser- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 A/C Condensers found
2005 Ford Freestyle Condenser Part Number: EU2Z-19712-G
$177.51 MSRP: $245.57You Save: $68.06 (28%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Kit - Air Conditioning Condenser; A/C Condenser
- Replaces: 5F9Z-19712-AA
- Item Weight: 10.60 Pounds
- Item Dimensions: 37.5 x 5.9 x 21.7 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: EU2Z-19712-G
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2005 Ford Freestyle Condenser Part Number: 5F9Z-19712-AA
Product Specifications- Other Name: Condenser Assembly; A/C Condenser
- Replaced by: EU2Z-19712-G
- Base No.: 19712
- Item Weight: 7.50 Pounds
- Item Dimensions: 37.5 x 5.9 x 21.5 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5F9Z-19712-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2005 Ford Freestyle A/C Condenser
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2005 Ford Freestyle A/C Condenser available at FordPartsDeal.com. You can confidently purchase our OEM 2005 Ford Freestyle A/C Condenser as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2005 Ford Freestyle A/C Condenser Parts Q&A
- Q: How to service and repair the A/C Condenser core of the HVAC system on 2005 Ford Freestyle?A: Start the condenser core service process by extracting the refrigerant from the HVAC system. Position the vehicle at neutral setting on a hoist. Start by removing the radiator grille followed by removing the bolt which allows you to place the horn assembly to the side. First detach the condenser outlet fitting through nut removal while disposing of the O-ring seal before tightening the new installation to 8 Nm (71 lb-in). Disconnect the condenser inlet fitting by doing the same procedure and discard the O-ring seal before tightening a new fitting to 8 Nm (71 lb-in). Begin by removing the four pin-type retainers and two stud retainers used for the radiator air deflector and replace them after reinstallation by tightening both components to 6 Nm (53 lb-in). To install reverse the removal process while replacing all O-ring seals with new ones and properly lubricate the refrigerant system with the specified amount of clean PAG oil. In the final step evacuate the refrigerant system before performing leak testing and then adding refrigerant through the charging process.