My Garage
Cart

OEM 2005 Ford Mustang Fuel Pump Driver Module

  • Select Vehicle by Model
  • Select Vehicle by VIN
Select Vehicle by Model
Make
Model
Year
or
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Fuel Pump Driver Module found

  • 2005 Ford Mustang Fuel Pump Driver Module - 6R3Z-9D372-BA
    2005 Ford Mustang Fuel Pump Driver Module Diagram - 6R3Z-9D372-BA
    View related parts

    2005 Ford Mustang Fuel Pump Controller, Driver Side Part Number: 6R3Z-9D372-BA

    $98.10 MSRP: $190.40
    You Save: $92.30 (49%)
    ADD TO CART
    Product Specifications
    • Other Name: Module - Engine Fuel; Fuel Pump Driver Module; Module
    • Position: Driver Side
    • Replaced by: 5L8Z-9D370-A
    • Base No.: 9D372
    • Item Weight: 1.10 Pounds
    • Item Dimensions: 3.1 x 3.5 x 6.8 inches
    • Condition: New
    • Fitment Type: Direct Replacement
    • SKU: 6R3Z-9D372-BA
    • Warranty: This genuine part is guaranteed by Ford's factory warranty.
    More Info
    Fits the following 2005 Ford Mustang Submodels:
    • Base, Bullitt, GT, Shelby GT | 6 Cyl 4.0 L GAS, 8 Cyl 4.6 L GAS

2005 Ford Mustang Fuel Pump Driver Module

If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2005 Ford Mustang Fuel Pump Driver Module available at FordPartsDeal.com. You can confidently purchase our OEM 2005 Ford Mustang Fuel Pump Driver Module as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.

2005 Ford Mustang Fuel Pump Driver Module Parts Q&A

  • Q: Where is the fuel pump driver module (FPDM) located and how to remove and install on 2005 Ford Mustang?
    A: The driver module of the fuel pump (FPDM) can be found in the spare tire storage compartment. Start with disconnecting the battery ground cable and proceed by separating the fuel pump driver module (FPDM) electrical connector. Detach the fuel pump driver module (FPDM) through removal of its two securing bolts followed by the module extraction step. To install the parts, you must tighten both bolts to 10 Nm (89 lb-in) before executing the reverse removal process for installation completion.