FordParts
My Garage
My Account
Cart
OEM 2005 Lincoln Aviator Automatic Transmission Filter
AT Filter- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Automatic Transmission Filter found
2005 Lincoln Aviator Filter Part Number: 1L2Z-7A098-AC
$44.08 MSRP: $70.00You Save: $25.92 (38%)Ships in 1 Business DayProduct Specifications- Other Name: Screen Assembly; Transmission Oil Filter; Hydraulic Filter, Automatic Transmission; Transmission Filter; Screen
- Replaces: 1L2Z-7A098-AB
- Base No.: 7A098
- Item Weight: 1.10 Pounds
- Item Dimensions: 15.3 x 11.1 x 0.6 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 1L2Z-7A098-AC
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2005 Lincoln Aviator Automatic Transmission Filter
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2005 Lincoln Aviator Automatic Transmission Filter available at FordPartsDeal.com. You can confidently purchase our OEM 2005 Lincoln Aviator Automatic Transmission Filter as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2005 Lincoln Aviator Automatic Transmission Filter Parts Q&A
- Q: How to service and repair the Transmission Pan and Automatic Transmission Filter on 2005 Lincoln Aviator?A: The servicability of automatic transmission fluid filters requires that you raise and stabilize the vehicle followed by setting up a drain pan beneath the transmission fluid pan. Drain the fluid by removing the plug located in the drain position. You can use the transmission fluid pan gasket again after cleaning it for inspection purposes and as long as it stays undamaged. The service requires removal of both the 16 transmission fluid pan screws followed by the fluid pan extraction and gasket removal. But first discard the transmission fluid filter and proceed with cleaning the transmission fluid pan while examining the magnet. The new filter installation requires applying transmission fluid only to seals for protection before you check their proper placement. Tighten the filter to 10 Nm (89 inch lbs.) value. The fluid pan magnet should be installed into the transmission fluid pan followed by a placement of the reusable gasket on the pan. Place the transmission fluid pan with gasket afterward while holding the screws loosely then cross-tighten them at 10 Nm (89 inch lbs.). To complete the procedure install the fluid drain plug while tightening it to 26 Nm (19 ft. lbs.) after partially filling the transmission as required.