FordParts
My Garage
My Account
Cart
OEM 2006 Ford F-150 Vehicle Speed Sensor
VSS- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Vehicle Speed Sensor found
2006 Ford F-150 ABS Sensor, Rear Part Number: 6L3Z-9E731-A
$37.55 MSRP: $60.56You Save: $23.01 (38%)Product Specifications- Other Name: Sensor Assembly - Tripminder; ABS Wheel Speed Sensor, Rear; ABS Speed Sensor; Speed Sensor; Rear Speed Sensor; Sensor; ABS Wheel Speed Sensor
- Position: Rear
- Base No.: 9E731
- Item Weight: 0.30 Pounds
- Item Dimensions: 6.4 x 4.0 x 4.0 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 6L3Z-9E731-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2006 Ford F-150 Vehicle Speed Sensor
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2006 Ford F-150 Vehicle Speed Sensor available at FordPartsDeal.com. You can confidently purchase our OEM 2006 Ford F-150 Vehicle Speed Sensor as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2006 Ford F-150 Vehicle Speed Sensor Parts Q&A
- Q: How to service and repair the vehicle speed sensor in the transmission on 2006 Ford F-150?A: Start your work on transmission speed sensors by supporting the vehicle at neutral in a hoist position. To replace the output shaft speed (OSS) sensor start by disconnecting its electrical connector followed by removing its sensor bolt then extracting the OSS sensor. Service the turbine shaft speed (TSS) sensor by first detaching its electrical connector then unscrewing the sensor bolt followed by taking out the TSS sensor. To install begin by applying lubricant to the O-ring seal before inserting the TSS sensor and then fasten it with a torque of 11 Nm (9 ft. lbs.) on the sensor bolt before reconnecting the electrical connector. First apply lubrication to the OSS sensor O-ring seal before putting it in position and tightening the sensor bolt to 12 Nm (9 ft. lbs.) while reconnecting the electrical connector.