FordParts
My Garage
My Account
Cart
OEM 2006 Ford Fusion Air Bag Sensor
Air Bag Impact Sensor- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Air Bag Sensors found
2006 Ford Fusion Side Impact Sensor Part Number: 9E5Z-14B345-A
$30.33 MSRP: $41.27You Save: $10.94 (27%)Product Specifications- Other Name: Sensor - Side Air Bag; Air Bag Impact Sensor; Air Bag Sensor; Side Sensor
- Replaces: 6E5Z-14B345-AA, 8E5Z-14B345-A
- Base No.: 14B345
- Item Weight: 0.30 Pounds
- Item Dimensions: 3.1 x 2.7 x 1.7 inches
- Condition: New
- Fitment Type: Direct Replacement
- Require Quantity: 4
- SKU: 9E5Z-14B345-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2006 Ford Fusion Front Sensor Part Number: 6E5Z-14B004-A
Product Specifications- Other Name: Sensor Assembly; Air Bag Impact Sensor, Front; Air Bag Sensor
- Position: Front
- Replaces: 6E5Z-14B004-AA
- Base No.: 14B004
- Item Weight: 0.40 Pounds
- Item Dimensions: 3.0 x 2.7 x 1.7 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 6E5Z-14B004-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2006 Ford Fusion Air Bag Sensor
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2006 Ford Fusion Air Bag Sensor available at FordPartsDeal.com. You can confidently purchase our OEM 2006 Ford Fusion Air Bag Sensor as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2006 Ford Fusion Air Bag Sensor Parts Q&A
- Q: What precautions should be taken when servicing the Air Bag Sensor in the B-pillar on 2006 Ford Fusion?A: Safety glasses must be worn when servicing the side impact sensor at the B-pillar because accidental air bag deployment poses a risk of injury. The vehicle sensor must be aligned correctly for system functionality while damaged SRS components must be replaced following a safety check no matter what condition the air bags are in. The installation of memory saver devices should be prohibited when safety hazards towards personal safety are at stake. When removing the restraints control module (RCM) fuse while the ignition switch remains ON the air bag warning lamp will illuminate as part of the normal operation although it does not represent a fault. The SRS requirements along with complete operational functionality must be met to give the vehicle back to customers and new part installation must happen with additional diagnostic checks if problems persist. Start by depowering the system and the removal of lower B-pillar trim panel allows access to disconnect the side impact sensor electrical connector. The correct operation of the system depends on the accurate tightening torque applied to the air bag side impact sensor retaining bolt thus all B-pillar and sensor mating areas should remain clean from debris with clear notes of sensor position along with locating tab for integration during reinstallation. Use the given procedures to remove the sensor bolt and side impact sensor before installing the new unit and torquing it to 12 Nm (9 lb-ft) before following the uninstallation steps before enabling system power.