FordParts
My Garage
My Account
Cart
OEM 2007 Ford Fusion Air Bag Sensor
Air Bag Impact Sensor- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Air Bag Sensors found
2007 Ford Fusion Side Impact Sensor Part Number: 9E5Z-14B345-A
$30.33 MSRP: $41.27You Save: $10.94 (27%)Product Specifications- Other Name: Sensor - Side Air Bag; Air Bag Impact Sensor; Air Bag Sensor; Side Sensor
- Replaces: 6E5Z-14B345-AA, 8E5Z-14B345-A
- Base No.: 14B345
- Item Weight: 0.30 Pounds
- Item Dimensions: 3.1 x 2.7 x 1.7 inches
- Condition: New
- Fitment Type: Direct Replacement
- Require Quantity: 4
- SKU: 9E5Z-14B345-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2007 Ford Fusion Front Sensor Part Number: 6E5Z-14B004-A
Product Specifications- Other Name: Sensor Assembly; Air Bag Impact Sensor, Front; Air Bag Sensor
- Position: Front
- Replaces: 6E5Z-14B004-AA
- Base No.: 14B004
- Item Weight: 0.40 Pounds
- Item Dimensions: 3.0 x 2.7 x 1.7 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 6E5Z-14B004-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2007 Ford Fusion Air Bag Sensor
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2007 Ford Fusion Air Bag Sensor available at FordPartsDeal.com. You can confidently purchase our OEM 2007 Ford Fusion Air Bag Sensor as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2007 Ford Fusion Air Bag Sensor Parts Q&A
- Q: What precautions should be taken when servicing the Air Bag Sensor in the C-pillar on 2007 Ford Fusion?A: Safety glasses should be worn when servicing the side impact sensor inside the C-Pillar to prevent injuries from possible air bag activations. The sensor orientation needs to be checked for correct system performance; inspect for bracket and wire damage if the vehicle experienced a collision because you will need to reinstall the sensor as well as replace any SRS parts regardless of air bag deployment status. Memory saver devices should be avoided to prevent personal injuries. The restraints control module (RCM) fuse removal during an ON ignition state will cause the air bag warning lamp to illuminate but this symptom does not indicate any SRS fault condition. A complete check of the SRS functionality must happen before sending a vehicle back to the customer. Once the repair step involves new component placement but if symptoms continue then return to original hardware and execute diagnostic routines again. First disable the power then detach the rear seat backrest side bolster along with disconnecting the side impact sensor electrical connector. It is essential to achieve proper tightening torque when replacing the air bag side impact sensor retaining bolts because the initial torque setting should reach 12 Nm (9 lb-ft). The position of the sensor along with the locating tab requires careful observation for correct installation. Also verify that both the C-pillar and side impact sensor mating surfaces remain debris-free. The new sensor installation requires following the same removal procedure in reverse order while connecting the system power supply.