FordParts
My Garage
My Account
Cart
OEM 2006 Lincoln Navigator Power Steering Cooler
- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Power Steering Cooler found
2006 Lincoln Navigator Power Steering Cooler Part Number: 2L1Z-3D746-CA
$265.93 MSRP: $390.50You Save: $124.57 (32%)Ships in 1-3 Business DaysProduct Specifications- Other Name: Coil - Cooling
- Base No.: 3D746
- Item Weight: 0.40 Pounds
- Item Dimensions: 4.4 x 4.6 x 14.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 2L1Z-3D746-CA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2006 Lincoln Navigator Power Steering Cooler
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2006 Lincoln Navigator Power Steering Cooler available at FordPartsDeal.com. You can confidently purchase our OEM 2006 Lincoln Navigator Power Steering Cooler as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2006 Lincoln Navigator Power Steering Cooler Parts Q&A
- Q: How to Service and Repair the Power Steering Cooler While Preventing Contaminants from Entering the System on 2006 Lincoln Navigator?A: The proper service and repair of the power steering cooler requires steps to stop contaminants from entering the power steering system because this protects system components from early failure. Hermetic power disconnect of the air suspension system through the LH rear quarter trim panel switch is essential for work safety since incomplete shutting down could trigger air spring inflation or deflation which leads to vehicle shifting and personal injury risk. Set the vehicle in neutral position and secure it on a hoist. To perform the replacement procedure on a Navigator you must first remove pushpins as well as deflectors from installation points. Two clamps should be released after disconnecting the power steering cooler hoses. Remove the two bolts that secure the power steering cooler before removing it from the position. The installation of the new cooler requires bolt tightening to 11 Nm (8 ft. lbs.) using the reverse procedure while also filling the power steering system during the reinstallation.