FordParts
My Garage
My Account
Cart
OEM 2006 Lincoln Town Car Ignition Switch
Starter Ignition Switch- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Ignition Switch found
2006 Lincoln Town Car Ignition Switch Part Number: 5W1Z-11572-AA
$41.23 MSRP: $65.47You Save: $24.24 (38%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Switch Assembly - Ignition
- Base No.: 11572
- Item Weight: 0.40 Pounds
- Item Dimensions: 6.2 x 4.0 x 4.1 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5W1Z-11572-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2006 Lincoln Town Car Ignition Switch
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2006 Lincoln Town Car Ignition Switch available at FordPartsDeal.com. You can confidently purchase our OEM 2006 Lincoln Town Car Ignition Switch as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2006 Lincoln Town Car Ignition Switch Parts Q&A
- Q: How to service and repair the ignition switch on 2006 Lincoln Town Car?A: The procedure of servicing and repairing the ignition switch begins with discharging the supplemental restraint system (SRS). Position the ignition switch lock cylinder to RUN before using the suitable tool to push the cylinder release tab upward followed by removing the lock cylinder outward. Start with removing the steering wheel tilt lever and handle before releasing the upper steering column shroud by pressing the sides in. Tighten the three screws that secure the upper and lower steering column shrouds to 2 Nm (18 inch lbs.) after reinstalling them. Start by disconnecting the electrical connector from the ignition switch followed by ignition switch screw removal and pulling out the switch unit before installation when the switch requires torque of 5 Nm (44 inch lbs.). The last step includes reversing the removal sequence while enabling power for the supplemental restraint system (SRS).