FordParts
My Garage
My Account
Cart
OEM 2006 Mercury Grand Marquis Transmitter
Car Key- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Transmitter found
2006 Mercury Grand Marquis Remote Control Part Number: 8S4Z-15K601-A
$65.53 MSRP: $75.00You Save: $9.47 (13%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Remote Control System; Keyless Entry Transmitter; Transmitter; Transceiver
- Manufacturer Note: 4 Buttons
- Replaces: 2S4Z-15K601-AB
- Base No.: 15K601
- Item Weight: 0.40 Pounds
- Item Dimensions: 6.3 x 4.2 x 2.1 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 8S4Z-15K601-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2006 Mercury Grand Marquis Transmitter
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2006 Mercury Grand Marquis Transmitter available at FordPartsDeal.com. You can confidently purchase our OEM 2006 Mercury Grand Marquis Transmitter as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2006 Mercury Grand Marquis Transmitter Parts Q&A
- Q: How to program the Remote Keyless Entry (RKE) transmitters on 2006 Mercury Grand Marquis?A: Setting all Remote Keyless Entry (RKE) transmitters at the same time is necessary for programming them. A key sequence of turning the key from OFF to RUN eight times throughout ten seconds will enter program mode while automatically locking and unlocking the doors for confirmation. The programming of each RKE transmitter begins when you press any button on it while the system also locks then unlocks the doors to verify successful programming. Each programming cycle for new transmitters should be completed within seven seconds or else the entire procedure will start from the beginning. The program mode will end when users wait at least seven seconds or pull the key to the OFF position. A twenty-second wait must occur after keying OFF or finishing all transmitter programs before starting transmitter verification tests.