FordParts
My Garage
My Account
Cart
OEM 2006 Mercury Milan Washer Reservoir
Windshield Washer Reservoir- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Washer Reservoir found
2006 Mercury Milan Washer Pump Part Number: 6E5Z-17618-A
$50.74 MSRP: $79.18You Save: $28.44 (36%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Reservoir - Water; Washer Fluid Reservoir; Windshield Washer Reservoir; Windshield Washer Pump; Reservoir Assembly
- Manufacturer Note: Includes Pump
- Replaces: 6E5Z-17618-AA
- Base No.: 17618
- Item Weight: 4.10 Pounds
- Item Dimensions: 18.7 x 12.4 x 9.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 6E5Z-17618-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2006 Mercury Milan Washer Reservoir
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2006 Mercury Milan Washer Reservoir available at FordPartsDeal.com. You can confidently purchase our OEM 2006 Mercury Milan Washer Reservoir as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2006 Mercury Milan Washer Reservoir Parts Q&A
- Q: How to service and repair the windshield washer reservoir on 2006 Mercury Milan?A: The servicing and repairing process for the windshield washer reservoir starts by positioning the vehicle on a hoist while keeping it in neutral gear. The service process starts by removing the fender shield from the right-hand front then disconnecting the electrical connector of the windshield washer pump. All safety instructions written on washer solution containers must be followed because the solution contains toxic methanol to protect from personal injury. A safe practice for fluid prevention requires emptying the windshield washer fluid before hose disconnect and pump removal. Screw the filler neck bolt of the windshield washer reservoir tightly to 7 Nm (62 lb-in) during reinstallation. After removing the fasteners of the reservoir first tighten each part to 7 Nm (62 lb-in) before reinstallation. Before operating the pumps remember to complete the reservoir with windshield washer fluid because operating them without fluid leads to premature pump failure.