OEM 2007 Ford E-250 Air Bag Control Module

2007 Ford E-250 Air Bag Control Module Parts Q&A

• Q: What precautions should be taken when servicing the air bag control module and RCM on 2007 Ford E-250?

  A: Safety glasses should always be worn when servicing the air bag control module to prevent injuries from possible accidental deployment. A correct orientation of the restraints control module (RCM) ensures proper air bag deployment in any situation but checking the mounting and bracket for deformation becomes necessary after a collision damages the driver seat floor area. Replace the RCM immediately in such cases. The RCM installation area needs to maintain its original state and you should never employ memory saver devices to decrease personal injury threats. Start the process of disconnection or reconnection of RCM electrical connectors by depowering the SRS and securely anchoring the RCM along with its bracket to the floor pan to safeguard against damage. The RCM fuse removal with ON ignition turns on the air bag warning lamp but this illumination is normal and means no faults exist. The SRS component requires depowering during all seat-related servicing operations. Verification of the installed RCM together with functional SRS testing and absence of faults must be completed before returning the vehicle to its customer. Replace each faulty part with new components yet return the original part in case the problem persists beforehand conducting another diagnostic check. The processing sequence begins with depowering the system followed by removing the driver seat and prying from the sides to get rid of the RCM cover clips before pulling it backward. Cleared the large RCM electrical connector through lever disengagement beginning at the thumb tab followed by pivot positioning of the connector assurance lever backward while removing it from its socket. Detach the small RCM electrical connector before unfastening the three bolts securing both RCM and bracket assembly. The RCM bracket retaining bolts require a torque of 12 Nm (9 lb-ft) but inspection for any corrosion should happen first. Connect the small RCM electrical connector only after the large RCM connector position assurance lever is completely open and released to do so. When installing the large RCM electrical wiring connector avoid angling it to prevent bad connections and component damage since light pressure should be used before using the lever for full connector seating. To complete the process install the RCM cover while reinstalling the driver seat then power on the system.