How to service the air inlet Blend Door Actuator on 2007 Ford Focus?

The first step for servicing the air inlet door actuator is to lower the glove compartment. Start the service of the air inlet mode door actuator by disconnecting its electrical connector. Remove the three screws that fasten the actuator in place. After removing the actuator the service process ends with the return of its original installation path.

OEM 2007 Ford Focus Blend Door Actuator

Air Blend Door Actuator

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Blend Door Actuator found

View related parts
2007 Ford Focus Actuator Part Number: 1M5Z-19E616-AA
$35.34 MSRP: $48.09
You Save: $12.75 (27%)
ADD TO CART
Product Specifications
- Other Name: Actuator Assembly; HVAC Air Inlet Door Actuator; HVAC Heater Blend Door Actuator
- Manufacturer Note: FROM 11/01/01
- Base No.: 19B634
- Item Weight: 0.50 Pounds
- Item Dimensions: 8.7 x 7.7 x 7.9 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 1M5Z-19E616-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
More Info
Fits the following 2007 Ford Focus Submodels:
- LX, S, SE, SES, ST, SVT, ZTS, ZTW, ZX3, ZX4, ZX4 ST, ZX5, ZXW | 4 Cyl 2.0 L GAS, 4 Cyl 2.3 L GAS

2007 Ford Focus Blend Door Actuator

If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2007 Ford Focus Blend Door Actuator available at FordPartsDeal.com. You can confidently purchase our OEM 2007 Ford Focus Blend Door Actuator as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.

2007 Ford Focus Blend Door Actuator Parts Q&A

Q: How to service the air inlet Blend Door Actuator on 2007 Ford Focus?
A: The first step for servicing the air inlet door actuator is to lower the glove compartment. Start the service of the air inlet mode door actuator by disconnecting its electrical connector. Remove the three screws that fasten the actuator in place. After removing the actuator the service process ends with the return of its original installation path.