My Garage
Cart

OEM 2007 Ford Freestar Rocker Arm

Engine Rocker Arm
  • Select Vehicle by Model
  • Select Vehicle by VIN
Select Vehicle by Model
Make
Model
Year
or
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Rocker Arm found

  • 2007 Ford Freestar Rocker Arm - E9SZ-6564-A
    2007 Ford Freestar Rocker Arm Diagram - E9SZ-6564-A
    View related parts

    2007 Ford Freestar Rocker Arms Part Number: E9SZ-6564-A

    $23.42 MSRP: $31.87
    You Save: $8.45 (27%)
    ADD TO CART
    Product Specifications
    • Other Name: Arm Assembly - Valve Rocker; Rocker Arm
    • Replaces: FOSZ-6564-A
    • Base No.: 6564
    • Item Weight: 0.50 Pounds
    • Condition: New
    • Fitment Type: Direct Replacement
    • Require Quantity: 12
    • SKU: E9SZ-6564-A
    • Warranty: This genuine part is guaranteed by Ford's factory warranty.
    More Info
    Fits the following 2007 Ford Freestar Submodels:
    • Base, Limited, S, SE, SEL, SES | 6 Cyl 3.9 L GAS, 6 Cyl 4.2 L GAS

2007 Ford Freestar Rocker Arm

If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2007 Ford Freestar Rocker Arm available at FordPartsDeal.com. You can confidently purchase our OEM 2007 Ford Freestar Rocker Arm as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.

2007 Ford Freestar Rocker Arm Parts Q&A

  • Q: How to service and repair the rocker arm assembly on 2007 Ford Freestar?
    A: Service and repair of the rocker arm assembly starts with cleaning the valve cover to avoid foreign substance entry that would result in engine failure. Before uninstalling the rocker arm bolts and pivots it is necessary to mark the rocker arms with their original positioning. Clean engine oil serves to lubricate rocker arms along with their pivots after inspection. Install the components with this oil. The installer should position both rocker arms and pivots before using hand tools to start the bolts and finish by tightening them to 5 Nm (44 inch lbs) then 32 Nm (24 ft. lbs). Finally, reinstall the valve cover.