FordParts
My Garage
My Account
Cart
OEM 2007 Ford Freestyle Steering Shaft
Steering Stem Shaft- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Steering Shaft found
2007 Ford Freestyle Shaft Assembly, Lower Part Number: 6F9Z-3B676-AA
Product Specifications- Other Name: Steering Shaft, Lower; Lower Shaft; Coupling; Steering Shaft
- Position: Lower
- Replaces: 5F9Z-3B676-AA
- Base No.: 3B676
- Item Weight: 3.80 Pounds
- Item Dimensions: 3.8 x 22.9 x 3.0 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 6F9Z-3B676-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2007 Ford Freestyle Steering Shaft
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2007 Ford Freestyle Steering Shaft available at FordPartsDeal.com. You can confidently purchase our OEM 2007 Ford Freestyle Steering Shaft as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2007 Ford Freestyle Steering Shaft Parts Q&A
- Q: How to service and repair the intermediate steering shaft on 2007 Ford Freestyle?A: You should start servicing or repairing the steering column shaft intermediate by positioning the vehicle on a hoist in neutral gear mode. Put the wheel shaft at straight-ahead direction while taking out the ignition key. The service starts with removing the steering column cover and then the intermediate shaft-to-steering column bolt requires 25 Nm (18 ft. lbs.) during reassembly. The maintenance process of the intermediate shaft boot bearing clamp requires keeping its clamping mechanism in open position when removing or installing either the clamp or boot bearing or boot assembly. Use an appropriate tool to loosen the intermediate shaft boot bearing clamp from the boot before detaching it from the shaft together with opening the clamp enough for boot removal. Then keep the clamp open for further work. The intermediate shaft-to-steering gear bolt needs to be taken out before performing reinstallation while tightening it to 23 Nm (17 ft. lbs.). Check that neither end tab of the intermediate shaft boot bearing clamp touches the boot post-installation and ensure the intermediate shaft boot bearing fits correctly inside its retention groove while the outer bearing race stays within the cartridge. The installation process should be performed by following the steps in reverse order to replace all components.