FordParts
My Garage
My Account
Cart
OEM 2007 Lincoln MKZ Drive Shaft
Axle Shaft- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Drive Shaft found
2007 Lincoln MKZ Drive Shaft Part Number: AE5Z-4R602-A
$630.00 MSRP: $861.54You Save: $231.54 (27%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Shaft Assembly - Drive; Driveshaft
- Replaces: 7E5Z-4R602-B, 7E5Z-4R602-A, 8E5Z-4R602-A
- Base No.: 4R602
- Item Weight: 68.30 Pounds
- Item Dimensions: 87.4 x 49.9 x 12.6 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: AE5Z-4R602-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2007 Lincoln MKZ Drive Shaft
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2007 Lincoln MKZ Drive Shaft available at FordPartsDeal.com. You can confidently purchase our OEM 2007 Lincoln MKZ Drive Shaft as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2007 Lincoln MKZ Drive Shaft Parts Q&A
- Q: How to Service and Repair the Drive Shaft on 2007 Lincoln MKZ?A: A proper service and repair procedure on the driveshaft starts by putting the vehicle into neutral gear on a hoist. Start every maintenance operation by waiting for exhaust system cooling because high operating temperatures exist near the catalytic converters so you can stay safe from injuries. Index-mark both driveshaft flanges for proper alignment. Separate the exhaust system at the flex pipe through removal of the 2 nuts while using a stand to support the exhaust system and removing its two front hangers. As a first step lower the exhaust system down to make enough room for driveshaft removal. The replacement of new CV joint bolts and washers remains essential because damage to the vehicle can result from using them again. Discard the 4 front driveshaft-to-transfer case bolts and washers and replace them with new bolts which need to be tightened to 70 Nm (52 ft. lbs.) when installed properly. The front driveshaft removal process requires discarding and replacing the 4 universal joint flange bolts while torquing new bolts to 70 Nm (52 ft. lbs.) during installation. When replacing the rear U-joint flange bolts do not use the existing pieces because you should discard them and add new bolts that need to be tightened to 70 Nm (52 ft. lbs.). Fitting assistance allows removal of the 4 center bearing support nuts and driveshaft while installation should use 55 Nm (41 ft. lbs.) torque on new nuts. Drive shaftumas should be addressed by indexing the shaft before performing a reverse installation using the same removal steps.
