OEM 2008 Ford Focus Washer Pump

2008 Ford Focus Washer Pump Parts Q&A

• Q: How to service and repair the windshield washer pump and reservoir on 2008 Ford Focus?

  A: Start the windshield washer pump and reservoir maintenance procedure by first removing the filler neck bolt then placing the degas bottle to the side after unscrewing its two bolts. The first step requires lifting the vehicle onto a hoist after placing it in neutral gear and then unmounting the radiator lower air deflector. Remove the windshield washer pump electrical connector while reading all safety information from the product label and consulting medical professionals if needed. The connector stays intact and undamaged when hand tools are not used for washer pump hose removal or installation procedures. You should empty the windshield washer fluid from the reservoir before pulling out the washer pump hose using gentle rotations of 90 degrees on its locking ring until it slides freely. Prevent leaks by ensuring proper hose installation where the piece rests completely deep inside the lock position while also keeping the lock ring out of the separated state. To begin the process remove the windshield reservoir through the procedure of removing its nut and two bolts. Operating the washer pump should be done only when the windshield washer reservoir has enough fluid since operating it without fluid causes premature pump failure. The installation process must end with the opposite steps of removal.