FordParts
My Garage
My Account
Cart
OEM 2008 Lincoln Mark LT Front Cross-Member
Front Engine Cross Member- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Front Cross-Members found
2008 Lincoln Mark LT Repair Kit, Front Part Number: 8L3Z-5019-A
Product Specifications- Other Name: Kit - Frame Rail Repair Front; Frame Rail, Front; Kit-Frame Rail Repair Front
- Position: Front
- Item Weight: 272.50 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 8L3Z-5019-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2008 Lincoln Mark LT Repair Kit, Front Part Number: 8L3Z-5019-B
Product Specifications- Other Name: Cross Member Assembly; Frame Rail, Front
- Position: Front
- Base No.: 5019
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 8L3Z-5019-B
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2008 Lincoln Mark LT Front Cross-Member
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2008 Lincoln Mark LT Front Cross-Member available at FordPartsDeal.com. You can confidently purchase our OEM 2008 Lincoln Mark LT Front Cross-Member as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2008 Lincoln Mark LT Front Cross-Member Parts Q&A
- Q: How to service the Front Cross-Member and Rear Crossmember of the transmission support on 2008 Lincoln Mark LT?A: Service operations for the transmission support crossmember should be started after placing the vehicle in neutral position and raising it on a hoist. Remove the exhaust hanger bolts first while tightening them to 40 Nm during reinstallation. The installation of the two heat shield screws should be done at 20 Nm (15 lb-ft) torque when you reinstall them. A proper jack should be used to support the transmission before you remove the two supporting transmission nuts that need a torque of 103 Nm (76 lb-ft) for installation. After removal of the four transmission support crossmember bolts continue with installation by tightening them to 115 Nm (85 lb-ft). After removing the transmission support crossmember you should replace it using the reverse order.