OEM 2008 Lincoln Mark LT Power Window Motor

2008 Lincoln Mark LT Power Window Motor Parts Questions & Experts Answers

• Q: How to service and repair the rear door power window motor on 2008 Lincoln Mark LT?

  A: The process of repairing the rear door window motor requires starting with removing pin-type retainers from the rear trim panel before proceeding to detach the entire panel. Start by dislodging the rear corner trim where SuperCab models need the B-pillar trim panel and SuperCrew owners have to eliminate the C-pillar trim panel. You must disconnect the electrical connector attached to the rear window glass motor as well as remov the three screws that fix the rear window glass regulator assembly to proceed with service. The plastic cable housing should be separated from the steel bracket through the removal of three retaining bolts. Before division the drum from the motor use a screwdriver to pry open the gap between the motor housing and plastic cable housing by holding them together while setting the screwdriver between the drum in cable housing and motor housing to prevent the drum from exiting the housing. To install the motor users should position the motor gear splines onto the drum and use force to press the motor in place until all bolt attachment holes are well aligned. Install the steel bracket bolts onto the plastic cable housing while also securing the screws which anchor the rear window glass regulator and motor assembly until they reach 11 Nm (8 lb-ft). Realign the electrical rear window glass motor connector and then rebuild the rear corner trim together with the B-pillar trim panel for SuperCab vehicles or the C-pillar trim panel for SuperCrew vehicles followed by installment of the rear trim panel and its pin-type retainers.