FordParts
My Garage
My Account
Cart
OEM 2008 Lincoln MKX Intake Manifold
Engine Intake Manifold- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Intake Manifolds found
2008 Lincoln MKX Intake Manifold, Lower Part Number: 7T4Z-9424-C
Product Specifications- Other Name: Manifold Assembly - Inlet; Engine Intake Manifold, Lower
- Position: Lower
- Base No.: 9424A
- Item Weight: 7.60 Pounds
- Item Dimensions: 18.5 x 8.1 x 6.1 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 7T4Z-9424-C
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2008 Lincoln MKX Intake Manifold, Upper Part Number: 7T4Z-9424-E
Product Specifications- Other Name: Manifold Assembly - Inlet; Engine Intake Manifold, Upper
- Position: Upper
- Base No.: 9424A
- Item Weight: 14.70 Pounds
- Item Dimensions: 17.6 x 15.7 x 13.2 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 7T4Z-9424-E
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2008 Lincoln MKX Intake Manifold
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2008 Lincoln MKX Intake Manifold available at FordPartsDeal.com. You can confidently purchase our OEM 2008 Lincoln MKX Intake Manifold as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2008 Lincoln MKX Intake Manifold Parts Q&A
- Q: How to service the lower intake manifold on 2008 Lincoln MKX?A: Maintaining the lower intake manifold necessitates the first step to position the vehicle on a hoist in neutral gear. The first step should be draining the cooling system before removing the fuel rail together with the air cleaner assembly. First disconnect the three bolts attaching the thermostat housing from the lower intake manifold then remove all ten lower intake manifold bolts. First discard the intake manifold and thermostat housing gaskets then clean and inspect all surfaces before discarding them. New intake manifold and thermostat housing gaskets serve as essential components during installation while you secure the ten bolts to lower intake manifold with a specific sequence of 10 Nm (89 lb-in) torque setting. Affix and tighten the three thermostat housing-to-lower intake manifold bolts to 10 Nm (89 lb-in). After finishing the procedure it is necessary to reinstall both the air cleaner assembly and the fuel rail followed by cooling system filling and bleeding operations.