FordParts
My Garage
My Account
Cart
OEM 2008 Mercury Sable Intake Manifold
Engine Intake Manifold- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Intake Manifolds found
2008 Mercury Sable Intake Manifold, Upper Part Number: 7T4Z-9424-D
$130.53 MSRP: $190.00You Save: $59.47 (32%)Product Specifications- Other Name: Manifold Assembly - Inlet; Engine Intake Manifold, Upper; Intake Plenum
- Position: Upper
- Replaces: 7T4Z-9424-DA
- Base No.: 9424A
- Item Weight: 10.50 Pounds
- Item Dimensions: 22.4 x 18.0 x 7.7 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 7T4Z-9424-D
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2008 Mercury Sable Intake Manifold, Lower Part Number: 7T4Z-9424-C
Product Specifications- Other Name: Manifold Assembly - Inlet; Engine Intake Manifold, Lower
- Position: Lower
- Base No.: 9424A
- Item Weight: 7.60 Pounds
- Item Dimensions: 18.5 x 8.1 x 6.1 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 7T4Z-9424-C
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2008 Mercury Sable Intake Manifold
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2008 Mercury Sable Intake Manifold available at FordPartsDeal.com. You can confidently purchase our OEM 2008 Mercury Sable Intake Manifold as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2008 Mercury Sable Intake Manifold Parts Q&A
- Q: How to service the lower intake manifold on 2008 Mercury Sable?A: The service procedure for the lower intake manifold requires draining the cooling system and removing the fuel rail first. You must remove three bolts which secure the thermostat housing to the lower intake manifold followed by removing all ten bolts that attach the lower intake manifold to its place. You must dispose of both intake manifold and thermostat housing gaskets before proceeding to clean all sealing surfaces. The eight new gaskets must be installed for positioning the manifold before securing it with the ten bolts which need a torque of 10 Nm (89 lb-in). Use new gaskets to bolt the three components of thermostat housing-to-lower intake manifold while tightening them to 10 Nm (89 lb-in). To finish the procedure install the fuel rail and perform cooling system fill-up and bleeding operations.