FordParts
My Garage
My Account
Cart
OEM 2009 Ford E-150 Wiper Motor
Windshield Wiper Motor- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Wiper Motors found
2009 Ford E-150 Wiper Motor, Front Part Number: LC2Z-17508-A
$144.82 MSRP: $229.96You Save: $85.14 (38%)Ships in 1-3 Business DaysProduct Specifications- Other Name: Motor Assembly - Wiper; Windshield Wiper Motor, Front; Motor
- Position: Front
- Condition: New
- Fitment Type: Direct Replacement
- SKU: LC2Z-17508-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2009 Ford E-150 Wiper Motor Part Number: 8C2Z-17508-B
$142.01 MSRP: $233.67You Save: $91.66 (40%)Ships in 1 Business DayProduct Specifications- Other Name: Motor Assembly - Wiper; Windshield Wiper Motor
- Replaces: WM-614, 5C2Z-17508-AA
- Base No.: 17508
- Item Weight: 4.40 Pounds
- Item Dimensions: 8.8 x 8.3 x 6.4 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 8C2Z-17508-B
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2009 Ford E-150 Wiper Motor
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2009 Ford E-150 Wiper Motor available at FordPartsDeal.com. You can confidently purchase our OEM 2009 Ford E-150 Wiper Motor as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2009 Ford E-150 Wiper Motor Parts Q&A
- Q: How to service the wiper motor on 2009 Ford E-150?A: Prior to servicing the wiper motor you need to remove pivot arms of windshield wipers first followed by the cowl top vent panels. After disconnecting both windshield wiper mounting arm and pivot shaft remove the access cover found in the dash panel and its retaining clip. Extract the motor of the wiper system by disconnecting the electrical connector while uninstalling its bolts and by tightening them to 4 Nm (35 lb-in) torques at installation time. The finish of the installation requires executing the removal steps in reverse order.