FordParts
My Garage
My Account
Cart
OEM 2009 Ford Focus Brake Caliper
Caliper- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Brake Calipers found
2009 Ford Focus Caliper, Front Driver Side Part Number: 8S4Z-2B121-B
Product Specifications- Other Name: Caliper Assembly - Brake - Less Pad; Disc Brake Caliper, Front Left; Brake Caliper Repair Kit; Caliper Assembly - Brake - Less Pads; Brake Caliper
- Position: Front Driver Side
- Base No.: 2B120
- Item Weight: 4.50 Pounds
- Item Dimensions: 7.9 x 4.6 x 10.5 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 8S4Z-2B121-B
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
- Product Specifications
- Other Name: Caliper Assembly - Brake - Less Pad; Disc Brake Caliper, Front Right; Brake Caliper Repair Kit; Brake Caliper
- Position: Front Passenger Side
- Replaces: 8S4Z-2B120-B
- Base No.: 2B120
- Item Weight: 4.50 Pounds
- Item Dimensions: 8.2 x 4.6 x 10.5 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 8S4Z-2B120-BA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2009 Ford Focus Brake Caliper
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2009 Ford Focus Brake Caliper available at FordPartsDeal.com. You can confidently purchase our OEM 2009 Ford Focus Brake Caliper as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2009 Ford Focus Brake Caliper Parts Q&A
- Q: How to remove and replace the brake caliper on 2009 Ford Focus?A: You should begin the brake caliper removal procedure by using only brake fluid that meets manufacturer standards and maintaining it clean to stop fluid contamination or component damage. Review all warning signs found on the product label and immediately consult a doctor in emergency cases. Any fluid that leaks from brake calibrators must be cleaned promptly with water when it contacts painted or plastic materials. The wheel needs to be taken off followed by removal of the brake caliper flow bolt which allows the brake flexible hose to be set aside while discarding the two copper washers. The bolt needs to be tightened to 35 lb-ft (48 Nm) during reinstallment. The brake caliper detachment starts when users remove two brake caliper guide pin bolts, installing them later at 28 Nm (21 lb-ft). Follow the removal steps backwards when installing with proper orientation of new washers and proceed to bleed the brake caliper system.