How to service the sunroof or moonroof panel on 2009 Ford Fusion?

You should begin service on sunroof or moonroof panels by opening the roof opening panel to position it at VENT. Open the roof opening panel to its VENT setting while removing the four screws that secure the glass panel of the roof opening by unfastening the upper portion of the concertina blind then placing it to the side. Before fastening the screws check that the roof opening panel glass lies exactly in the center and is aligned properly before you tighten the screws. Secure them at 6 Nm (53 lb-in) torque. You must initialize the motor for the roof opening panel after finishing this installation.

OEM 2009 Ford Fusion Sunroof

Moonroof

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Sunroof found

View related parts
2009 Ford Fusion Sunroof Glass Part Number: 6E5Z-54500A18-A
$358.89 MSRP: $527.00
You Save: $168.11 (32%)
Product Specifications
- Other Name: Glass
- Manufacturer Note: Includes Seal
- Replaced by: 9E5Z-54500A18-A
- Base No.: <500A18
- Item Weight: 27.00 Pounds
- Item Dimensions: 38.8 x 24.7 x 5.1 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 6E5Z-54500A18-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
More Info
Fits the following 2009 Ford Fusion Submodels:
- S, SE, SEL | 4 Cyl 2.3 L GAS, 6 Cyl 3.0 L GAS

2009 Ford Fusion Sunroof

If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2009 Ford Fusion Sunroof available at FordPartsDeal.com. You can confidently purchase our OEM 2009 Ford Fusion Sunroof as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.

2009 Ford Fusion Sunroof Parts Q&A

Q: How to service the sunroof or moonroof panel on 2009 Ford Fusion?
A: You should begin service on sunroof or moonroof panels by opening the roof opening panel to position it at VENT. Open the roof opening panel to its VENT setting while removing the four screws that secure the glass panel of the roof opening by unfastening the upper portion of the concertina blind then placing it to the side. Before fastening the screws check that the roof opening panel glass lies exactly in the center and is aligned properly before you tighten the screws. Secure them at 6 Nm (53 lb-in) torque. You must initialize the motor for the roof opening panel after finishing this installation.