How to service the blower motor resistor on 2009 Ford Mustang?

Gain access to the blower motor resistor through the bottom of the instrument panel on the right. Unplug the electrical connector, and remove the two fixing screws and the resistor. Replacement is done by inverting the steps used to remove the resistor: place the resistor, screw it down, and reattach the electrical connector.

OEM 2009 Ford Mustang Blower Motor Resistor

Heater Blower Motor Resistor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Blower Motor Resistor found

View related parts
2009 Ford Mustang Blower Motor Resistor, Front Part Number: 3F2Z-18591-AA
$43.05 MSRP: $69.45
You Save: $26.40 (39%)
ADD TO CART
Product Specifications
- Other Name: Resistor Assembly; HVAC Blower Motor Resistor, Front; HVAC Blower Motor Regulator; Resistor; HVAC Blower Motor Resistor
- Position: Front
- Base No.: 19A706
- Item Weight: 0.30 Pounds
- Item Dimensions: 6.3 x 4.0 x 4.0 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 3F2Z-18591-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
More Info
Fits the following 2009 Ford Mustang Submodels:
- Base, Bullitt, GT, Shelby GT, Shelby GT500, Shelby GT500KR | 6 Cyl 4.0 L GAS, 8 Cyl 4.6 L GAS, 8 Cyl 5.4 L GAS

2009 Ford Mustang Blower Motor Resistor

If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2009 Ford Mustang Blower Motor Resistor available at FordPartsDeal.com. You can confidently purchase our OEM 2009 Ford Mustang Blower Motor Resistor as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.

2009 Ford Mustang Blower Motor Resistor Parts Q&A

Q: How to service the blower motor resistor on 2009 Ford Mustang?
A: Gain access to the blower motor resistor through the bottom of the instrument panel on the right. Unplug the electrical connector, and remove the two fixing screws and the resistor. Replacement is done by inverting the steps used to remove the resistor: place the resistor, screw it down, and reattach the electrical connector.