FordParts
My Garage
My Account
Cart
OEM 2010 Ford Explorer Sport Trac Front Cross-Member
Front Engine Cross Member- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Front Cross-Member found
Product Specifications- Other Name: Member Assembly - Cross Center; Floor Pan Crossmember; Center Reinforcement; Crossmember; Member Assembly - Cross - Center
- Position: Center
- Base No.: <10624
- Item Weight: 12.40 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 6L2Z-7810624-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2010 Ford Explorer Sport Trac Front Cross-Member
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2010 Ford Explorer Sport Trac Front Cross-Member available at FordPartsDeal.com. You can confidently purchase our OEM 2010 Ford Explorer Sport Trac Front Cross-Member as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2010 Ford Explorer Sport Trac Front Cross-Member Parts Q&A
- Q: How to service and repair the Rear Crossmember and Front Cross-Member for transmission support on 2010 Ford Explorer Sport Trac?A: Start the transmission support crossmember service by placing the vehicle into neutral on a hoist system. The installation requires you to first remove the four transfer case skid plate bolts then take away the transfer case skid plate which should be tightened to 15 Nm (133 lb-in) before reinstalling it. Begin by uninstalling the right heat shield bolt until it reaches 18 Nm (159 lb-in) torque after which install the left heat shield bolt following the same specifications. Insert a suitable jack under the transmission for support before untightening the two transmission mount nuts that need to be fastened to 90 Nm (66 lb-ft) during reinstallation. Remove the six lower bolts from the transmission crossmember before installation while tightening them to 80 Nm (59 lb-ft). During the reinstallation step secure the transmission crossmember with 143 Nm (105 lb-ft) torque on both upper nuts and bolts. Execute the reverse order of removal to install the transmission crossmember.