How to service and repair the front brake pads on Ford Edge?

You should start the front brake pad servicing by using approved DOT 3 brake fluid which prevents permanent damage to brake components and makes the brakes inoperable which could lead to personal injury. Read all warnings on the product label carefully then obtain urgent medical attention in case of need. In the USA or Canada, for Ford/Motorcraft products, call 1-800-959-3673 for additional information. The brake master cylinder reservoir needs its fluid level checked while removing fluid to achieve a level that occupies 1/2 of the tank capacity if needed. Secondly you must detach the assembly of wheel together with its tire. Using a finger to retract the pistons in the caliper sight hole will cause damage to the components. Keep the brake caliper separate from the brake hose because this method will avoid causing damage to the equipment. Secure the caliper with support wire while you remove its two guide pin bolts to position it on the side. Inspection of all components reveals their condition by removing brake pads together with brake pad shims and stainless steel shims. Remove the brake pad slides. The proper installation of new brake pads requires a suitable tool to protect caliper piston and boots and compress the disc brake caliper pistons within the caliper during installation. Apply a thin layer of supplied grease onto both brake pad shims and the shim contact zone of the brake pads before installing the brake pad slides. When installing brake pads users should first place each stainless steel shim onto position ensuring to distinguish the guide pin bolts which differ in length where the longer bolt matches the upper guide pin bolt. Position the brake caliper before you install its two guide pin bolts which need to be tightened to 88 Nm (65 ft. lbs.). After installing the wheel and tire assembly you should fill the brake master cylinder reservoir with clean specified brake fluid to test brake system normal operation.

OEM Ford Edge Brake Pads

Disc Brake Pad Set

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

11 Brake Pads found

View related parts
Ford Edge Brake Pads, Rear
Part Number: 7T4Z-2V200-AA
$45.79 MSRP: $66.65
You Save: $20.86 (32%)
Ships in 1 Business Day
ADD TO CART
Product Specifications
- Other Name: Kit - Brake Lining; Disc Brake Pad Set, Rear; Rear Pads; Disc Brake Pad Set
- Manufacturer Note: Ford Retail Spec
- Position: Rear
- Replaced by: 7U2Z-2V200-D
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2007-2010 Ford Edge | Limited, SE, SEL, SEL Plus, Sport | 6 Cyl 3.5 L GAS
View related parts
Ford Edge Brake Pads, Rear
Part Number: DG9Z-2200-F
$66.29 MSRP: $99.98
You Save: $33.69 (34%)
Ships in 1 Business Day
ADD TO CART
Product Specifications
- Other Name: Pad - Brake; Disc Brake Pad Set, Rear; Disc Brake Pad Kit; Rear Pads; Disc Brake Pad Set
- Position: Rear
- Replaces: BRF-1434, DG9Z-2200-D, BRF-1500
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2015-2024 Ford Edge | SE, SEL, Sport, ST, ST-Line, Titanium | 4 Cyl 2.0 L GAS, 6 Cyl 2.7 L GAS, 6 Cyl 3.5 L GAS
View related parts
Ford Edge Brake Pads, Front
Part Number: 7U2Z-2V001-G
$46.59 MSRP: $66.65
You Save: $20.06 (31%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Kit - Brake Lining; Disc Brake Pad Set, Front; Front Pads
- Position: Front
- Replaces: 7T4Z-2001-A, BR-1258-B, BR-1258-C, 7T4Z-2V001-AA, BT4Z-2001-A, J2MZ-2V001-L, 7U2Z-2V001-D, BRF-901, BT4Z-2001-B
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2007-2014 Ford Edge | Limited, SE, SEL, SEL Plus, Sport | 4 Cyl 2.0 L GAS, 6 Cyl 3.5 L GAS, 6 Cyl 3.7 L GAS
View related parts
Ford Edge Brake Pads, Rear
Part Number: EU2Z-2V200-E
$44.51 MSRP: $66.65
You Save: $22.14 (34%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Pad - Brake; Disc Brake Pad Set, Rear; Rear Pads
- Position: Rear
- Replaces: 8A8Z-2V200-A, BR-1377-C, BRF-1377-A, BT4Z-2200-A, BR-1377, J2MZ-2V200-G, CT4Z-2200-A, BRF-1441, EU2Z-2V200-D, EU2Z-2V200-A, G2MZ-2V200-AD, BR-1377-B
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2011-2014 Ford Edge | Limited, SE, SEL, Sport | 4 Cyl 2.0 L GAS, 6 Cyl 3.5 L GAS, 6 Cyl 3.7 L GAS
View related parts
Ford Edge Brake Pads, Rear
Part Number: K2GZ-2200-A
$68.69 MSRP: $99.98
You Save: $31.29 (32%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Kit - Brake Lining; Disc Brake Pad Set, Rear; Disc Brake Pad Kit; Disc Brake Pad Set; Rear Pads
- Position: Rear
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2019-2024 Ford Edge | SE, SEL, ST, ST-Line, Titanium | 4 Cyl 2.0 L GAS, 6 Cyl 2.7 L GAS
View related parts
Ford Edge Brake Pads, Red
Part Number: M2GZ-2001-A
$87.59 MSRP: $127.50
You Save: $39.91 (32%)
ADD TO CART
Product Specifications
- Other Name: Kit - Brake Lining; Front Pads
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2021-2024 Ford Edge | SE, SEL, ST, ST-Line, Titanium | 4 Cyl 2.0 L GAS, 6 Cyl 2.7 L GAS
View related parts
Ford Edge Brake Pads, Red, Front
Part Number: F2GZ-2001-P
$83.47 MSRP: $121.50
You Save: $38.03 (32%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Kit - Brake Lining; Disc Brake Pad Set, Front; Front Pads
- Position: Front
- Replaces: BRF-1473, F2GZ-2001-C, BRF-1476, F2GZ-2001-K, BRF-1552, F2GZ-2001-A, F2GZ-2001-H, BRF-1855
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2015-2020 Ford Edge | SE, SEL, Sport, ST, ST-Line, Titanium | 4 Cyl 2.0 L GAS, 6 Cyl 2.7 L GAS, 6 Cyl 3.5 L GAS
View related parts
Ford Edge Brake Pads, Front
Part Number: F2GZ-2001-M
$99.16 MSRP: $144.33
You Save: $45.17 (32%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Kit - Brake Lining; Disc Brake Pad Set, Front; Disc Brake Pad Kit; Disc Brake Pad Set; Front Pads
- Position: Front
- Replaces: BRF-1543, BRF-1551, F2GZ-2001-F, F2GZ-2001-G
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2015-2023 Ford Edge | SE, SEL, Sport, ST, ST-Line, Titanium | 4 Cyl 2.0 L GAS, 6 Cyl 2.7 L GAS, 6 Cyl 3.5 L GAS
View related parts
Ford Edge Brake Pads, Red
Part Number: K2GZ-2001-A
$109.01 MSRP: $211.67
You Save: $102.66 (49%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Kit - Brake Lining; Front Pads
- Manufacturer Note: Warranty Eligible
- Replaced by: K2GZ-2001-B
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2019-2024 Ford Edge | SE, SEL, ST, ST-Line, Titanium | 4 Cyl 2.0 L GAS, 6 Cyl 2.7 L GAS
View related parts
Ford Edge Brake Pads, Red
Part Number: F2GZ-2001-Q
$77.98 MSRP: $120.00
You Save: $42.02 (36%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Kit - Brake Lining
- Replaces: BRF-1861, F2GZ-2001-L
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2019-2020 Ford Edge | SE, SEL, ST, ST-Line, Titanium | 4 Cyl 2.0 L GAS, 6 Cyl 2.7 L GAS
View related parts
Ford Edge Front Pads
Part Number: F2GZ-2001-L
$77.98 MSRP: $120.00
You Save: $42.02 (36%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Kit - Brake Lining; Disc Brake Pad Set, Front; Brake Pads
- Manufacturer Note: Warranty Eligible
- Position: Front
- Replaced by: F2GZ-2001-Q
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2019-2021 Ford Edge | SE, SEL, ST, ST-Line, Titanium | 4 Cyl 2.0 L GAS, 6 Cyl 2.7 L GAS

Ford Edge Brake Pads

Welcome to our website where you can discover high-quality, genuine Ford Edge Brake Pads. We offer an extensive inventory of OEM Ford Edge Brake Pads at affordable prices. We are committed to providing top-rated customer service along with prompt delivery.

Ford Edge Brake Pads Parts Questions & Experts Answers

Brake Pads, Front
7U2Z-2V001-G
Q: How to service and repair the front brake pads on Ford Edge?
A: You should start the front brake pad servicing by using approved DOT 3 brake fluid which prevents permanent damage to brake components and makes the brakes inoperable which could lead to personal injury. Read all warnings on the product label carefully then obtain urgent medical attention in case of need. In the USA or Canada, for Ford/Motorcraft products, call 1-800-959-3673 for additional information. The brake master cylinder reservoir needs its fluid level checked while removing fluid to achieve a level that occupies 1/2 of the tank capacity if needed. Secondly you must detach the assembly of wheel together with its tire. Using a finger to retract the pistons in the caliper sight hole will cause damage to the components. Keep the Brake Caliper separate from the brake hose because this method will avoid causing damage to the equipment. Secure the caliper with support wire while you remove its two guide pin bolts to position it on the side. Inspection of all components reveals their condition by removing brake pads together with brake pad shims and stainless steel shims. Remove the brake pad slides. The proper installation of new brake pads requires a suitable tool to protect caliper piston and boots and compress the disc brake caliper pistons within the caliper during installation. Apply a thin layer of supplied grease onto both brake pad shims and the shim contact zone of the brake pads before installing the brake pad slides. When installing brake pads users should first place each stainless steel shim onto position ensuring to distinguish the guide pin bolts which differ in length where the longer bolt matches the upper guide pin bolt. Position the brake caliper before you install its two guide pin bolts which need to be tightened to 88 Nm (65 ft. lbs.). After installing the wheel and tire assembly you should fill the brake master cylinder reservoir with clean specified brake fluid to test brake system normal operation.