Warranty: This genuine part is guaranteed by Ford's
factory warranty.
Fits the following Vehicles:
2015-2024 Ford Edge | SE, SEL, Sport, ST, ST-Line, Titanium | 4 Cyl 2.0 L GAS, 6 Cyl 2.7 L GAS, 6 Cyl 3.5 L GAS
Ford Edge Window Regulator
Welcome to our website where you can discover high-quality, genuine Ford Edge Window Regulator. We offer an extensive inventory of OEM Ford Edge Window Regulator at affordable prices. We are committed to providing top-rated customer service along with prompt delivery.
Ford Edge Window Regulator Parts Questions & Experts Answers
Q: How to service the rear door window regulator and motor on Ford Edge?
A: The service of rear door window components begins with taking out the speaker unit from the door. Before cutting the window regulator cable it is important to support the window glass unless you plan to install a new window regulator assembly. Chose the window control switch as the first test to confirm that the window operates. After unplugging the access there you should lower the window glass and tape it in place before removing the glass clamp bolt. The regulator needs support before loosening the glass clamp bolt. When reinstalling tighten it to 9 Nm (80 lb-in). The technician should lower the regulator to its bottom position on the track stops before disconnecting the electrical slot at the B-pillar. Use the speaker hole for access to release the clip attaching the harness to your door by removing its two securing bolts from the electrical harness grommet. Guided by the Weather Strip you can unclip and insert the wiring harness into the opening between door weather strip and door. The three door latch screws need removal followed by tightening them to 9 lb-ft during reinstallation. Take out the access plug from the door latch side followed by unscrewing the outside Door Handle reinforcement screw then the handle itself. The screw should be secured to 8 Nm (71 lb-in) when reinstalling it. When installing the module rear door remove first the keypad from the door followed by removal of nine door module bolts after which you can take out the module moving its components then readjust the bolts to 9 Nm (80 lb-in) torque specification. You should perform the installation by reversing the removal steps.