Warranty: This genuine part is guaranteed by Ford's
factory warranty.
Fits the following Vehicles:
2004-2008 Ford F-150 | FX2, FX4, Harley-Davidson Edition, King Ranch, Lariat, Limited, STX, THE 60TH ANNIVERSARY EDITION, XL, XLT | 6 Cyl 4.2 L GAS, 8 Cyl 4.6 L GAS, 8 Cyl 5.4 L FLEX, 8 Cyl 5.4 L GAS
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
Fits the following Vehicles:
2004-2008 Ford F-150 | FX2, FX4, Harley-Davidson Edition, King Ranch, Lariat, Limited, STX, THE 60TH ANNIVERSARY EDITION, XL, XLT | 6 Cyl 4.2 L GAS, 8 Cyl 4.6 L GAS, 8 Cyl 5.4 L FLEX, 8 Cyl 5.4 L GAS
| Page 1 of 3 |Next >
1-20 of 47 Results
Ford F-150 Muffler
Welcome to our website where you can discover high-quality, genuine Ford F-150 Muffler. We offer an extensive inventory of OEM Ford F-150 Muffler at affordable prices. We are committed to providing top-rated customer service along with prompt delivery.
Ford F-150 Muffler Parts Questions & Experts Answers
Q: How to service and repair the muffler and tailpipe on Ford F-150?
A: Start the muffler and tailpipe repairs only after securing the vehicle into NEUTRAL position on a hoist. Application of oil or grease based lubricants on the isolators should be avoided because they cause the rubber to deteriorate thus separating the exhaust hanger bracket from its position during operation. When a new exhaust intermediate pipe requires installation with a Torca(R) clamp assembly then both components must be added. To remove the muffler and tailpipe assembly start by loosening the exhaust intermediate pipe-to-muffler and tailpipe assembly clamp followed by securing front, rear, and tailpipe exhaust hanger bracket bolts from the frame. The first step for installation requires the use of an abrasive pad to clean surface rust from the exhaust Torca(R) clamp area before positioning the muffler and tailpipe assembly. Place the front and rear and tailpipe exhaust hanger brackets and isolators onto the frame before tightening them using 30 Nm torque (22 lb-ft). Push the tailpipe assembly forward for the collar on the hanger bracket to meet the isolator while the insertion button of the extension pipe inlet passes fully into the L-notch of the tailpipe assembly. You should install the new exhaust intermediate pipe-to-muffler assembly Torca(R) clamp during the installation of a new exhaust intermediate pipe and apply torque of 47 Nm (35 lb-ft) to the exhaust intermediate pipe-to-muffler and tailpipe assembly exhaust clamp. Conduct the exhaust system alignment procedure before moving on because the exhaust system isolators remain at non-zero loads.