OEM Ford Mustang Flywheel Ring Gear

Ford Mustang Flywheel Ring Gear Parts and Q&A

• Ring Gear
  C5AZ-6384-D
  Q: How to Properly Handle and Install the Flywheel Ring Gear on a Ford Mustang?

  A:

  The service process for the Flywheel ring gear begins with flywheel removal. Only properly equipped and experienced torch users who perform this task can handle the work successfully. The ring gear needs tongs or asbestos gloves when being heated to prevent human injuries. The flywheel ring gear should receive equal tapping to prevent binding before heating with an acetylene torch and then driving off the flywheel with a brass drift. The proper installation of components requires only individuals who hold qualifications as acetylene torch operators. Heating the flywheel ring gear should stop at the temperature of 261° C (500° F). Control the heat with heat-indicating crayons and maintain constant torch movement to prevent excess heat accumulation. Position the flywheel ring gear towards the rear of the flywheel with its bevel facing outward and drive it into place through repetitive tapping with a brass drift while thermal processing as needed during the installation process.
• Ring Gear
  F6ZZ-6384-AA
  Q: How to Service and Repair the Flywheel Ring Gear on Ford Mustang?

  A:

  Service and repair of the Flywheel ring gear starts with removing the attached flywheel component. The acetylene torch service and repair must only be done by operators who are properly equipped and have experience in using this equipment. The ring gear of the hot flywheel requires tongs or asbestos gloves to prevent human injuries. Grasp the flywheel ring gear from all directions before acetylene torch heating for uniform heat distribution. Then use the brass drift to start it off the flywheel using smooth taps. The job of installing the flywheel ring gear requires only qualified acetylene torch operators to perform it. Heating the flywheel ring gear other than up to 261°C (500°F) must be avoided since periodic inspections with heat-indicating crayons alongside continuous torch movement help prevent localized hot areas. Strive to position the flywheel ring gear and its bevel at the wheel's back by applying a brass drift after necessary reheat sessions before flywheel replacement.