Escape | 2020 | SE, SE Plug-In Hybrid, SE Sport Hybrid, SEL, SEL Plug-In Hybrid, Titanium, Titanium Hybrid, Titanium Plug-In Hybrid | 3 Cyl 1.5 L GAS, 4 Cyl 2.0 L GAS, 4 Cyl 2.5 L FULL HYBRID EV-GAS (FHEV), 4 Cyl 2.5 L PLUG-IN HYBRID EV-GAS (PHEV)
Escape | 2021-2022 | SE, SE Hybrid, SE Plug-In Hybrid, SEL, SEL Hybrid, SEL Plug-In Hybrid, Titanium, Titanium Hybrid, Titanium Plug-In Hybrid | 3 Cyl 1.5 L GAS, 4 Cyl 2.0 L GAS, 4 Cyl 2.5 L FULL HYBRID EV-GAS (FHEV), 4 Cyl 2.5 L PLUG-IN HYBRID EV-GAS (PHEV)
Other Name: Visor Assembly - Sun; Sun Visor, Right
Position: Passenger Side
Fits the following Ford Models:
Expedition | 2018-2021 | King Ranch, Limited, Max King Ranch, Max Limited, Max Platinum, Max SSV, Max XL, Max XLT, Platinum, SSV, XL, XLT | 6 Cyl 3.5 L GAS
Fusion | 2015-2016 | Energi SE, Energi Titanium, S, S Hybrid, SE, SE Hybrid, Titanium, Titanium Hybrid | 4 Cyl 1.5 L GAS, 4 Cyl 2.0 L FULL HYBRID EV-GAS (FHEV), 4 Cyl 2.0 L GAS, 4 Cyl 2.0 L PLUG-IN HYBRID EV-GAS (PHEV), 4 Cyl 2.5 L GAS
A: Service of the sun visor begins by removing the visors after unscrewing them and disconnecting any lighted vanity mirror relay. The installation process for sun visors begins by performing the opposite steps to those used for removal.
Q: How to service the sun visor on Ford Excursion?
A: Service of the sun visor begins by removing screws (36041A32) and disposing of them. Fully detach the sun visor (3604118) from the vehicle by using strong force on the gasket adhesive. Disconnect its electrical connector at the same time. The next step requires the removal and disposal of sun visor gasket (36500A16). To remove rear rivet nuts from the vehicle a user needs to extract the headliner first. Check the relevant specifications to see if the hole is outside its specifications. The installation of new sun visor retaining screws or rivet nuts requires grinding or drilling of screw heads and rivet nut ends until they are flush before using a punch to pass the remaining length of rivet nut through the hole followed by new rivet nut installation. When replacing the sun visor gasket it becomes necessary to clean both sun visor and roof panel contact surfaces while wrapping electrical connector components with anti-rattle tape before performing reinstallation procedures in reverse order.
Q: How to Remove and Replace a Sun Visor on Ford F-350 Super Duty?
A: Removing the inside sun visor (part number 04100) starts with unfastening it from the visor arm clip. You should access the screws by positioning the visor before removing them. The removal process starts with taking out the inside visor after screw removal. The installation requires a reverse order of the removal steps.