Ford XW2Z-19712-AA
Condenser

Analysts should start HVAC condenser maintenance by executing the Refrigerant Discharging and Recovery Procedure. Use left-hand side pins to support the radiator then lift the vehicle into position. Secure the radiator splash shield before performing the procedure to ensure all lines and connections remain sealed through the use of plugs. Extract the air conditioning condenser from the radiator crossmember after disconnecting its upper and lower lines from the condenser. Detach the right along with left-hand side radiator brackets while keeping the radiator fins free from damage. Push the radiator towards the compressor to its maximum while simultaneously detaching the condenser top mountings to perform the removal. The installation process requires reversing the previous steps of removal and a check of normal A/C system operation should be performed. New O-rings need application of refrigerant oil before installation to achieve correct sealing performance and operational functionality.

Start HVAC condenser service and repair by reclaiming the refrigerant and then by raising the vehicle support. The first step requires you to remove the radiator splash shield before disconnecting the air conditioning condenser tubes from both the upper and lower locations. Prepare the tube ports with plugs for sealing purposes. Start by detaching the condenser from the radiator crossmember before removing it by lifting it up while pushing towards the grille to disassemble its top mountings without harming the radiator fins. Use the opposite procedure for installation then complete quality checks on the air conditioning system to verify its normal operation functions. New O-ring seals require refrigerant oil application for sealing purposes before installation.

The Refrigerant Discharging and Recovery Procedure needs to be completed first before starting HVAC condenser maintenance. Raising and supporting the vehicle should be your first step before removing the radiator splash shield. Seal the tubes and connections of the air conditioning condenser before detaching its upper and lower tubes. Proceed by detaching the condenser from the radiator crossmember before you can remove it by lifting it upward while pushing it towards the grille while avoiding contact with radiator fins. To install new O-ring seals the technician should coat them with refrigerant oil before following the reverse step of removal. The air conditioning operation should be verified during the final checks.

Analysts should start HVAC condenser maintenance by executing the Refrigerant Discharging and Recovery Procedure. Use left-hand side pins to support the radiator then lift the vehicle into position. Secure the radiator splash shield before performing the procedure to ensure all lines and connections remain sealed through the use of plugs. Extract the air conditioning condenser from the radiator crossmember after disconnecting its upper and lower lines from the condenser. Detach the right along with left-hand side radiator brackets while keeping the radiator fins free from damage. Push the radiator towards the compressor to its maximum while simultaneously detaching the condenser top mountings to perform the removal. The installation process requires reversing the previous steps of removal and a check of normal A/C system operation should be performed. New O-rings need application of refrigerant oil before installation to achieve correct sealing performance and operational functionality.

Begin by performing the Refrigerant Discharging and Recovery Procedure.