Ford 9L5Z-14A664-A
Clockspring

The first step for Clock Spring assembly servicing requires the Supplemental Restraint System (SRS) to be depowered before starting. When working with air bag modules keep the deployment door in an opposite direction from your body so unexpected deployments stay prevented. Controlling the air bag warning indicator requires the removal of the driver air bag module when using the appropriate Restraints Control Module (RCM) fuse during the ON ignition state. The steering wheel position needs to be straight ahead during the removal process of both the steering wheel and ignition lock cylinder. The hood release handle and steering column opening trim panel require two screws for removal and then the clips can be released for extraction of the lower steering column opening finish panel. First detach five bolts while removing the steering column opening cover reinforcement in addition to removing the tilt release lever/handle when equipment allows. The lower steering column shroud requires three screw removal before installing the upper shroud to gain access to the Clock Spring clips. Disconnect all wires from the Clock Spring before disconnecting the electrical connectors that include the wiring ground and releasing the lower Clock Spring clip. Before extricating the Clock Spring it is necessary to detach the screw and Passive Anti-Theft System (PATS) antenna and key-in-ignition warning indicator switch from the lock cylinder housing. During installation with new Clock Spring remove the key after positioning the rotor at center without rotation. In order to recenter the outer housing remains stationary while rotating the counterclockwise until resistance feels then rolling it clockwise to a desired 2.25 turns toward the center point. Install the PATS antenna and key-in-ignition warning indicator switch before installing the Clock Spring in the correct position along the steering column with tabs engagement. The electrical connectors plus ground wire need connection before upper and lower steering column shrouds receive position and secure installation along with the tilt release lever/handle and the steering column opening cover reinforcement which requires four bolts tightened at 8 Nm (71 lb-in). Position the wheels straight ahead as you put back the ignition lock cylinder and steering wheel and then install lower steering column trim and hood release handle. The procedure ends by reinstalling the driver air bag module while powering up the SRS system.

Replace any air bag modules with discolored or damaged trim covers.

Disconnect the clockspring electrical connectors and release the lower retaining clip.