Ford 6L2Z-78500A18-A
Glass Panel

The roof opening panel glass servicing process begins by initializing the roof opening panel motor when any work happens on repair sections affecting the motor, glass, or assembly in addition to new component installments. Start by opening the roof opening panel to VENT mode and afterward remove four screws which keep the roof opening panel glass in place but tighten them to 4 Nm (35 lb-in) when reinstalling. The technician should uninstall the roof opening panel glass assembly after stepping out of the vehicle. Pay special attention to each corner during the installation of new roof opening panel glass seal to achieve proper sealing. Complete the installation process by ensuring proper placement of the roof opening panel then running the roof opening panel motor initialization.

Service of roof opening panel glass must start with motor initialization when performing maintenance on the roof opening panel system especially after removing the motor or glass or assembly components or installing new parts. Start the service of roof opening panel glass by swinging the roof opening panel to VENT position. Secure the roof opening panel glass in place through four screws by tightening them to 4 Nm (35 lb-in) during reinstallation. Use care when removing the roof opening panel glass assembly from outside vehicle surface. Follow the uninstallation procedure backward while exercising caution when sealing corners to achieve the required seal with new roof opening panel glass. To complete the procedure verify that the roof opening panel maintains proper alignment and enable the roof opening panel motor.

Service of the roof opening panel glass must begin with motor initialization after any roof opening panel system repair that includes motor removal, glass replacement or assembly maintenance or new component installation. Initiate the service of the roof opening panel glass by placing it into the vent position. Secure the roof opening panel glass with four screws applying 4 Nm of torque after reinstallation. From outside the vehicle carry out the careful removal of the roof opening panel glass assembly. The corners of new installments must receive special attention because a proper seal depends on them. After roof opening panel alignment users should run the roof opening panel motor to finish the procedure.