Ford 6C2Z-15264A32-AA
Lock Assembly, Lower

The procedure for rear door latch replacement starts by removing the door trim panel when present before moving the watershield out of the way. The next step involves removing two nuts and both the interior door handle and bezel. You should disconnect the door lock actuator rivet when it exists. The side door installation process starts by detaching both the door lock cylinder actuating rod and the exterior door handle actuating rod. First disconnect the exterior door handle activating cable from the side door when the E-Guard Cargo Protection System applies. Before installing the rear door backing camera users must disconnect power connections and should unfasten the 4 screws holding the plate housing before safely placing it out of the door path. The door latch cable needs removal alongside the door lock cylinder actuating rod. You should disconnect the door latch cable from doors which utilize the E-Guard Cargo Protection System after moving the 4 license plate housing screws. The door lock cylinder cover can now be easily slid off after you have removed its two bottom-mounted tabs. To approach all door removals start by taking out the door latch remote control screw followed by the 3 door latch screws allowing access to the door latch assembly. Delete the door lock actuator electrical connector when it is available. Reverse installation requires the same procedure as removal while tightening fasteners to 12 Nm (106 lb-in) and using the Heavy Duty Riveter to place new rivets.

Remove the bolt and nut along with the sliding door lower latch itself.

Remove the license plate housing screws, pull the housing away from the door, then disconnect the handle-to-latch cable at the door handle and the lock cylinder rod at the lock cylinder.

Remove the door latch, latch remote control cable, lock cylinder rod, push-button rod, and power door lock actuator.

Remove the three screws and the lower door latch, tightening to 12 Nm (9 lb-ft) during installation.

Take out the three screws and set the rear sliding door latch aside.

Disconnect the lock cylinder rod from the lock cylinder lever and the outside door handle-to-latch rod at the door latch.

Remove the bolts and drill out the actuator rivet if it is equipped.

Reverse the removal procedure.

Remove the latch remote control, push button rod, lock cylinder rod, outside handle rod, and power door lock actuator.

Reverse the removal procedure to complete the installation.

Unscrew the license plate housing screws, pull the housing away from the door, then disconnect the handle-to-latch cable at the door handle and the lock cylinder rod at the lock cylinder.

Tighten the bolt to 12 Nm (106 lb-in).

Disconnect the outside door handle-to-latch rod.

Begin by removing the door trim panel if equipped, and then position the watershield aside.

Remove the bolt and nut along with the sliding door lower latch itself.

Reverse the removal procedure to complete the installation.

Remove the screw and slide the interior door handle forward to disengage the tabs from the door.

Begin by removing the door trim panel if equipped, and then position the watershield aside.

Disconnect it from the lock cylinder lever.

Remove the three screws and the lower door latch, tightening to 12 Nm (9 lb-ft) during installation.

Remove the license plate housing screws, pull the housing away from the door, then disconnect the handle-to-latch cable at the door handle and the lock cylinder rod at the lock cylinder.

Release the appropriate actuation cable clip by pushing the bottom keeper upward and sliding the clip toward the outside of the door, followed by disconnecting the cable from the interior door handle.

Remove the license plate housing screws and pull the housing away from the door, then disconnect the handle-to-latch cable at the door handle and the lock cylinder rod at the lock cylinder.