Ford F5RZ-17664-A
Washer Pump

The service and repair of the windshield washer pump starts with removing the windshield washer reservoir filler neck followed by raising the vehicle to achieve adequate support. Begin by disconnecting the electrical parts from the washer reservoir while pulling off all attached hoses. After disconnecting the electrical connector and hoses the windshield washer pump and its rubber gasket can be extracted. Vehicles with the headlamp washer system need headlamp washer pumps removed together with their rubber seals by disconnecting wires and hoses prior to raising them out. The installation procedure requires users to press a supplementary cap onto the back vent tube of the reservoir while ensuring that both front and rear ventilation tubes stay properly aligned. Follow the correct procedure if strong acceleration or deceleration causes the washer system water to leak from the filled reservoir. For reservoir installation workers need to reverse the removal steps keeping in mind application of Vaseline to the filler neck for correct installation.

The first step for servicing windshield washer pump and reservoir requires disconnecting the battery to guarantee safety. To begin the windshield washer reservoir service you need to first secure the right-front splash shield out of place while also collecting windshield washer fluid in a container by disconnecting the hose. First remove the three reservoir securing screws before extracting the unit where subsequent installation needs a torque setting of 6 Nm (53 lb-in). The washer motor and pump assembly must be uninstalled after disconnecting its electrical connector. The installation will finish when you follow the step-by-step process for returning to normal condition.

Service and repair of the windshield washer pump requires users to first empty the reservoir by following safety procedures since the methanol in washer fluid poses health risks to personnel. The first step involves disconnecting the washer reservoir through deinstallation of fender splash shield bolt and front bumper removal followed by electrical connector and hose separation. After removing the washer pump you should also remove the rubber seal that accompanies it. To install this piece backward remove all steps but apply soap suds to the rubber washer of the pump before putting it in place.

Raise the vehicle and remove the wheelhouse trim panel by taking out six bolts.

Disconnect the electrical connector and hoses, then lift out the pump along with the rubber gasket.

Follow the appropriate procedure for addressing concerns about washer system water leaking during strong acceleration or deceleration.

Position it aside by removing the screws and pin-type retainers.

Reverse the removal procedure.

Caution must be taken to avoid making electrical connections or operating the windshield washer pump before filling the windshield washer reservoir.

Position the RF splash shield aside.

It is crucial not to make any electrical connections or operate the windshield washer pump before filling the windshield washer reservoir.

The washer fluid contains methanol, which is poisonous and can cause personal injury if mishandled.