Ford YF1Z-9C735-BA
Servo Assembly

Service and repair of the cruise control servo requires disconnecting the battery first step. First disconnect the speed control actuator electrical connector through its connector tab until it separates apart. A release of the speed control cable cap happens when you push its retaining tab and rotate the cap counter-clockwise until detachment from the actuator housing occurs. The core wire end of the speed control cable requires manual pushing of the spring retainer followed by smooth sliding out from the actuator pulley. A person must disconnect the cable before removing the speed control actuator by unfastening its attaching nuts followed by taking out the actuator component. Drain the final bracket of the speed control actuator housing. The installation process should follow the opposite steps of removal.

Begin the cruise control servo service and repair procedure by disconnecting the grounding connection of the battery. The next step entails separating the speed control servo electrical connector after depressing the connector tab. Push the retaining tab of the speed control cable cap to release it. The cap can then be turned counterclockwise before pulling it away from the servo housing. The speed control cable requires disconnecting through spring release of its retainer while moving the core wire end away from the speed control servo pulley. Uninstall the speed control servo by removing its two nuts before removing the servo itself. The installation process ends by unfastening the bracket from the speed control servo using screws. Follow the opposite steps from removal to install the parts.

Remove the two nuts and ensure to tighten them to 20 Nm (15 lb-in) upon reinstallation.

Reverse the removal procedure.