Ford 7C3Z-3600-DA
Steering Wheel, Camel

Service and repair of the steering wheel starts with dissembling the driver air bag module. Set the steering wheel to straight ahead before removing the bolt which ends up in disposal and tighten a new bolt to 40 Nm (30 ft. lbs.) when reinstallation occurs. Remove the steering wheel with caution when passing wiring through the Clock Spring. Service of the steering wheel requires a new bolt installation followed by proper reverse order of removal steps.

The first step to work on the steering wheel involves removing the driver air bag module before proceeding. First position the steering wheel at a straight line before removing and discarding the steering wheel bolt. The installation requires a fresh bolt which must be tightened to 40 Nm (30 lb-ft). When removing the steering wheel both the wires from the Clock Spring and the steering wheel should pass through it carefully. Wrap the steering wheel Clock Spring central rotor to avoid its rotation by applying tape to the exterior housing. To finish the installation replace the steering wheel following the reverse order of removal.