Expedition | 2018-2021 | King Ranch, Limited, Max King Ranch, Max Limited, Max Platinum, Max SSV, Max XL, Max XLT, Platinum, SSV, XL, XLT | 6 Cyl 3.5 L GAS
Expedition | 2018-2021 | King Ranch, Limited, Max King Ranch, Max Limited, Max Platinum, Max SSV, Max XL, Max XLT, Platinum, SSV, XL, XLT | 6 Cyl 3.5 L GAS
Q: How to service and repair the steering wheel on Ford Explorer?
A: Start servicing or repairing the steering wheel by positioning it at straight ahead then turn the ignition switch to OFF. Service of the steering wheel begins by disconnecting the driver air bag module while separating the electrical connector from steering wheel switches. Service requires replacement of the existing steering wheel bolt along with the warming wheel so discard these components before installation. The new steering wheel requires a torque of 40 Nm (30 ft. lbs.) on its bolt before following the reverse steps of removal to finish installation.
Q: How to service the steering wheel on Ford Focus?
A: Start wheel steering servicing by taking out the driver air bag module from its place. Start by positioning the steering wheel at straight ahead before setting the ignition switch to OFF. Speed control systems require to disconnect their electrical connector before proceeding with the service. To begin proceed with bolt removal that secures the steering wheel before you uninstall it. The installation of a new steering wheel requires 50 Nm torque on the bolt which must be accompanied by central air bag sliding contact positioning for safety. Steering wheel positioning should be checked after installation by turning it counter-clockwise on the steering column shaft before finishing the installation procedure.
Q: How to service and repair the steering wheel while ensuring safety on Ford Mustang?
A: Before servicing or repairing the steering wheel it is necessary to disconnect the battery ground cable while waiting for one minute to allow the restraint system back up power supply to run out. Steer the wheel to a direct position before you confirm the ignition switch remains in OFF position. Any attempts at deactivating the Supplemental Restraint System (SRS) must adhere to all warnings cautions notes along with instructions to prevent dangerous personal injuries. Follow SRS deactivation procedures before the removal of the driver air bag module according to all defined safety protocols. Eliminate the steering wheel retaining bolt from its position before discarding it. A suitable puller will protect column bearings while removing the steering wheel and correct placement of wires from the Clock Spring should happen during steering wheel removal. The installation of a new steering wheel should be performed by repeating the steps exactly in reverse order. Reactivation of the Supplemental Restraint System (SRS) needs execution following all listed safety warnings and instructions to minimize serious personal injury potential.